Recent content by makuka

Hey there CoralTech, that solution finally worked, and now the system is working normally Thank you so much for your support

ok settings on 10-58 done, now i'm going to reboot both systems

Hey there CoralTech, here are the settings in both systems: Building A 10-58 Area table from 1 to 8 IP Address: 0.0.0.0 and Subnet Mask: 0.0.0.0 (nothing defined) 84-26 01 VOIP DSP IP Address: 192.168.5.11 02 RTP Port: 10020 03 RTCP Port: 10021 04 IP Address for Browser Phone Communication...

The gateway of the network is 192.168.5.1, and both switches are only gigabit poe, but no layer 2

Hi there CoralTech, thanks for the answer, here i will attach the ip config from the backup of both systems

Thanks for the reply, i will attach an image to make it easier, also here i will add some more info Both Sl 2100 are installed in the same LAN network located in two different towers in the same building, with no internet. SL 2100 on building "A" has the operator extension on a IP7WW-12TXH-A1...

So in the second sl 2100 i should change the ip address on the second row? i ask because in the screenshot i see with two different routes poiting to the ip address of the main sl 2100

Looking at the config via PCPro i see different ip address configured under Quick Install/Trunks/SIP Trunks/Profile/Interconnect IP without Registration/Interconnect Remote Destinations. I will upload screenshots of that config

Thanks for the reply, I'm viewing the backup of both systems, on the main SL 2100 Looking via quick install Quick Install/Trunks/SIP Trunks/Profile 1/Interconnect IP without registration/Interconnect Remote Destinations Sys nº: 0001 System Interconnection: Enable Ip Address...

Thanks for the reply, the sip trunk was working and after a power cut, it began with the problem, on Main sl 2100 i have the operator, dialing 0, and also the extension numbering plan with 3xxx, in the other sl 2100 extensión numerbing plan on 4xxx and dialing 0 for operador, but when i dial On...

Hi guys, noob on nec here... In this scenario there are 2 nec sl 2100 coneccted via lan and both have sip trunk license, but the extensions can't call from the sl 2100 a trhough the nec sl 2100 b, later i Will update with more info. Becuase i don't know if i can check the trunk status, i tried...

Hey guys of the forum, i have a problem with 3 slt on a Officeserv 7030. In the Office i have installed an Officeserv 7030 master cabinet with another officeserv slave cabinet. The problem is that i have 3 slt in the slave cabinet that can't get co line access, i have created 3 new virtual slt...