Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by majikhands

  1. majikhands

    Phaser 740

    hey alfa, no I haven't. But if anyone needs parts, I now own 4 of these that I have picked up at auctions. Have also found a great source for refilling the cartridges and we have run thousands of pages through our units with very little problems. I think I have a total of $500.00 invested in all...
  2. majikhands

    When to declare a printer dead

    depends on how much! The shipping alone is about 100.00. I can pick one up on ebay for 100.00-300.00. what city & state are you located?
  3. majikhands

    When to declare a printer dead

    if anyone wants to sell a 740 for parts, let me know. Have two of them and the power supply burned out on one of them. Xerox wants $434.00! They work great but they are a bit finicky. Please respond to 877-384-0295 or steve.kreger@islandsoftwareco.com
  4. majikhands

    Phaser 740 "Jam at A"

    There is a little black plastic clutch on the paper feed tray. If you are facing the circuit board on the left hand side, you will see it to the left of the transfer roller. It has a small plastic protrusion that catches. It will only turn one way. This is the culprit. Carefully remove the...
  5. majikhands

    Half used consumables and auto shut off in 560

    Hi all, Having the same problem with the fuser roll. Have seen several postings about the fuse. I guess I'll step out as the dumb one and ask....WHERE IS THIS FUSE ON THE FUSER ROLL? everyone talks about it and that it needs to be changed but no one says where or how. Would appreciate the help...
  6. majikhands

    Phaser 740

    Hi all, Have a similar problem. Purchased a 740 with fuser roll in it but had the "fuser roll: replace" message. I installed a new fuser roll, but the message persisted. I have a service manual and it says that the counter will reset after 250 sheets. The problem is, now it says "stopped" "fuser...
See more

Part and Inventory Search

Back
Top