Recent content by madess

If I migrate my licenses to the new Presentation Server license server format, will my old servers still work. I currently have 1 Presentation server 4, and the rest of my servers are Metaframe XPE. thank you for any advice Matt

What updates do you have to do to windows 2k to get presentation server 4 to run?

ok, what happens is if you call from location A where the PBX is, it goes to a Fxo on a cisco router, then to the location B. If I call the number (from A), wait a couple of rings and hang up it says proceeding under SHOW VOICE CALLS and the phone on the other end (B) continues to ring for...

so basically size of the packet

3d17h: IP: s=10.54.1.6 (Serial0/0.612), d=10.12.64.1, len 40, rcvd 4 what does the len mean? thanks Matt

I have a location that needs to have traffic going to one specific ip to have priority. How would I do this, the hardware at each end is a cat 5500 with atm interfaces. thanks for any help.

I have some users that work from home fire off batch jobs on the mainframe that run for quite sometime and of course their citrix sessions timeout, and well frankly that is the way it is supposed to be, I don't want people logged on to my servers hours at a time with idle sessions. Is there a...

I have just added a nm-1t3/e3 card to my 3745 and it shows up in show ver as 1 Subrate T3/E3 port but the module does not show up in show int? what the heck?

I have a 3620 with ds3 card that is only getting 5 mbs and it is supposed to be getting 45 mbs. I am going to start a large ftp process - what would would be the best way to monitor the line - show ? - debug ? thanks Matt

Ok, I have a 3725 with 8 port ima card and 3620 with a ds3 card. I want to switch the two cards between the routers. I tried it once and failed. The cards came up and worked, but the router that now has the ima - the 3620 would no longer route the packets? I could not get to any of the...

Building configuration... Current configuration : 5084 bytes ! version 12.3 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname wl45btdc ! boot-start-marker boot system flash c2801-advsecurityk9-mz.123-8.T6.bin boot-end-marker ...

I have been trying to setup a vpn, and I can not figure out how to bring up the session. Here is one router config, I will do a reply with the second. Current configuration : 4699 bytes ! version 12.3 service timestamps debug datetime msec service timestamps log datetime msec service...

Is there anyway to move equipment to a new data center without changing ip addresses? Is there a piece of Cisco equipment that would help with this? I have a good sized budget so... thanks Matt

Is there some place to look up the thru put cabablities of a router - basically how much traffic can they route? Like 1.5 mbs - 45 mbs? Maybe there is not an exact amount but perhaps what is recommended for each series of routers? thanks Matt

I have two 1700 series routers and I am trying to route thru the ethernet interface, then thru a vlan ip address that i gave to the ports on a wic 4esw card, and it doesn't seem to be working. thanks Matt