Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Mace0410

  1. Mace0410

    Problems with IExplorer 6 !

    If I were you I would trash IE6.0 and reinstall IE 5.0. They haven't gotten all the bugs out of 6.0 yet, but they don't tell you that untill after you've installed it.
  2. Mace0410

    No way to format partition, new install win98

    You might not have made the partition active. Run FDisk again and make sure the partition is active and is set as a logical drive.
  3. Mace0410

    problems with scandisk when trying to istall win 98

    You can run the scan disk in DOS, by starting the computer in DOS and at the c: prompt, type "scandisk" when the dialog box opens up, just check thorough and then start and you are on your way.
  4. Mace0410

    Boot up problem

    When I perform a warm boot, I have no problems booting up. But after leaving the machine shut down over night, in the morning it only gets as far as the splash screen and then stops. I have restarted and tried to load windows in DOS, but I get an error saying that HIMEM is missing. I have...
  5. Mace0410

    problems with scandisk when trying to istall win 98

    Before trying to format, try and run a scan disk from dos, but change the type of scan to thorough. This will perform a surface scan and take a long time to run, but will detect any bad clusters and repair it, by isolating the bad clusters and making the clusters unusable.
See more

Part and Inventory Search

Back
Top