Hi,
Did you try to get help about sip_route command from mdsh shell?
I think that there are more values than yes/no
and maybe one of them uses "preferred" instead of "asserted" id.
I saw that last week but when I was looking for another problem.
Regards
Hi Jaakie,
I had a similar problem a long time ago...
Could you trace AUR1 unit when sending the command KSEXE.
You will get fetregaut signal , then check the bytes D4&D5
and try the follwing:
First:
sacop:lim=x,unit=aur1,filno=1,point=(bytes D4&D5),reloff=07&08; (take note of the data)
If...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.