Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Lazrum
-
IPSEC VPN to cisco 2611 router
It looks like you need to add an acl to your crypto isakmp client configuration to allow your subnet traffic. add this ACL: access-list 101 permit ip 192.168.1.0 0.0.0.255 any Crypto config: crypto isakmp client configuration group 3000client key test123 dns 192.168.1.1 pool ippool *ACL...- Lazrum
- Post #2
- Forum: Virtual Private Networks (VPN)
-
NAT translations won't work
Ok, It turns out my ISP did change something with the config that required me to manually set the WAN interface to full duplex, speed 100. That solved the issue from the previous post. Everything including NAT translations is working fine now. Thank you everyone for your help. Here is my final... -
NAT translations won't work
I was able to play around with the router today but didn't get too far. I plugged the ethernet cables in and normally 3 lights for both interfaces are lit. This time only the LAN interface (e0/1) was completely lit and the WAN interface (e0/0) had the "link" and "100" light blinking (normally... -
NAT translations won't work
Sounds good. I'll be able to try those suggestions out hopefully either thursday or friday. Ill keep you guys posted and thank you for all the replies. -
NAT translations won't work
Ahh, almost solved it. I'm now able to reach my mail filter but none of the other servers from the outside. They are accessibe from the inside still. It's actually quite strange because everytime I plug the router in to test the config out it steals my filemaker server's ip address. After a... -
NAT translations won't work
I have been messing around with some NAT translations for a couple of weeks now and still cant seem to connect to internal servers from the outside. From what I've researched, my config is correct so im puzzled. Can anyone help me out? Current configuration : 4117 bytes ! version 12.4...
