Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Shaun E on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by LanworX
-
GBIC Link between 3550 switches
Thanks for all your help guys (and gals) but I have solved my problem! I have configured the gi0/1 port as so no switchport ip address 192.168.102.103/24 and similarly at the other end and the the link has come up! transferrifn routing over the link using RIPv2 and all seems to be well. Whew ! -
GBIC Link between 3550 switches
Nope that had no effect. Still have no link lights on and int gi0/1 still down/down. Is it better to set the ports to ISL rather than dot1q? -
GBIC Link between 3550 switches
The running config is this:- sh run Building configuration... Current configuration : 3670 bytes ! version 12.1 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption ! hostname BLK_Testbench ! enable secret 5 $1$mRmQ$ilou5JNSyHmZE2HQa6P/W/... -
GBIC Link between 3550 switches
Nope i didn't set a VTP password. Which part of the config do you need ? -
GBIC Link between 3550 switches
OK just did a loopback and i saw the interface come up and then go to diable state as you said. GigE ports are configured thus interface GigabitEthernet0/1 switchport trunk encapsulation dot1q switchport mode trunk no ip address one swith cis set to VTP server the other client, and both... -
GBIC Link between 3550 switches
Hi, I am trying to connect two Cisco 3550 switches using the Gi0/1 interfaces. I am assuming that i need to setup a trunk between the two switches over this L2 connection, but I seem to have a more fundamental problem than that. After inserting a 1000SX GBIC module into the switch i would have...
