Recent content by ky123

Thanks for your help. 1) Can the ECM be push installed??? I found a reference implying it can be pushed out, but I can not find any instructions or way to push it out. 2) Any reason not to run the EIS and the Execview console on the same computer?

You asked: >>Can you explain: Do you have 125 media servers? Yes we do have 125 media servers. At least I think that we do - I have been thrown into something that I know little about. We have 125 servers with tape drives installed -- I think that by definition means each server is a media...

I am brand new to a situation with 125 servers using BE9 on Win2000 servers. No monitoring of the backups is being done currently - I need a good policy and setup to make sure the backups are working every night. Is there a good way to monitor that number of servers centrally? Options I know...

The backup phone stations are in different areas of the building. I don't think an external ringer in 200 would work. What do you mean by "watch the Call Forward No Answer/Busy paths"? >Make a phantom DN with answer keys on the target >telephones... watch your CFNA/Busy paths or...

I have a single trunk line that appears and rings on a single station right now. MICS system. On no answer or busy it fowards to voice mail currently. I need to be able to foward that calls to a group of backup stations -- but only for that one external phone line - don't want to forward...

Schlum - Thanks for the info. I will need the 6 speakers and maybe more - it is for an office environment. Two floors and speakers to be placed in generally in various common areas where there is a single phone, but it is often tied up keeping others in the area from hearing pages. I am going...

Have a MICS and I'm going to add external paging speakers. I need about 6 speakers which will range from 30-150 feet from the MICS. Any recommendations on how to wire it and type of speakers to use? As an aside the installation manual wiring chart shows the 'external page' on 41/16. I...

OK, thanks. The software cartridge is labeled as follows: NNTM8455 DHVC 2000/9/03 NT7B64GA 0004 REL002 MICS-DR 4.1 S/W WI 06.04 I was assuming that we had the NA version when I looked at this, but I wasn't certain since it didn't say. How can I specify the software part number for the XC...

I have a ICS system that I am very comfortable programming, but expansion is causing me a problem. We have a 6 port fiber module with 4 ports currently used (2 for 0x16 SM; 1 for 12x0 TM; 1 for Voice Mail). We need to add three 0x16 SM modules. To support this we need to add an additional 6...