Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by knocknamaddy
-
router diaster
Have managed to get rommon back on again, i went to the cisco site and the commands they had to fix this problem was: rommon1>MONRC = BOOT = Flash:,n; rommon2>sync rommon3>reset when i do this it just gos back to the same error message as before.- knocknamaddy
- Post #3
- Forum: Cisco
-
router diaster
Hi there, i have a 2610 series router in the university where i am studying. When i turned it on this morning it was in rommon mode. I then issued the following commands to reload from flash rommon1>MONRC=BOOT=Flash:,n; rommon2>Sync (this saves the change) rommon3>reset (to take effect) this...- knocknamaddy
- Thread
- Replies: 4
- Forum: Cisco
