Recent content by kgornek

Thanks!

Can anyone tell me what the last software release was for the NEC 2400 IMX? I'm currently on release 8 from 8/9/2000. [neutral]

Or just T/R?

I assume by "all phones" you mean Nortel M phones? Because I know all the NEC phones in my office use straight line cords.

Can someone tell me if the M3903 and M3904 phones (on the Option 11C) take a straight or reversed line cord please? I believe I ran into this issue a long time ago on a Option 61C with a M2616 phone and I'm pretty sure the line cord needed to be reversed. Or am I just getting old and losing my...

If I change the cfw key information, is there a way to remotely activate it? It's to a external number and I do have CFXA for a CLS I changed it in LD 20 CHG 3904 yes key 19 cfw 16 912301231234 I changed the button but how do I activate it remotely?

Can someone tell me if the NEC 2400 IMX will support inbound Caller ID with name? We currently have the inbound number only and I've had requests for adding the name feature as well.

I’m looking for a solution or alternative to having two keys for a single extension appearance on a non-primary phone. For instance, a secretary would like to have a button on her phone with her manager's extension on it to see if he is on the phone, answer his incoming calls, and be able to...

I just needed the right manual. Found it. Thanks.

Does anyone know where to find all the index meanings for the ASYDL command in the 2400 IMX? I've looked through all my manuals and can't find anything outlaying what each of the sys/index represents.

Thanks for all the good info. I'm going to do some more research on the Octel. As far as the 2400, everything I've read so far states needing a non-load restart, but if there's another way, that would be even better.

Ok, there is no available ADTM command but I did look at the ASYDL command and now realize how to set the IP, Subnet, and Gateway addresses. Just a few questions: Will this affect my direct connection to the terminal in the room on the IOC port? I read that I will have to perform a SINZ...

I have two network connections to each of my SN1455 CPRAQ-A cards going to a network Hub and was wondering if there was a way to access this PBX via an IP address with MAT software? Is there a command to find/change the programmed IP address for access? There are no IP phones on this PBX as it's...

I have a group of DID's that are assigned to me by the LEC but not assigned in the PBX. Whenever you call one of these numbers it routes to the main console instead of a fast busy or a unassigned recording. I looked at the translations and can't find anything that would route it here. Any...

That worked! Thanks.