Recent content by kaneranch

Thanks but what i cant work out is what is the total as below shows 83227k/15077k?? what exactly does the entry mean. cisco 1760 (MPC860P) processor (revision 0x500) with 83227K/15077K bytes of memory. Processor board ID FOC08031E12 (1024463411), with hardware revision 0000 MPC860P processor...

I am trying to calculate how much memory is on our 1760 routers and cant see what the total is. The fash and nram ok but not the dram total. Any help would be appreciated.

Does anyone know if it is possible to make a manual isdn data call from a cisco.I know you can make a test call.I use the isdn for backup of our wan interface etc, but there are occasions when we need to put the link on isdn backup.I can get around it by pulling out the wan cable but this is not...

Has anyone tried using ios version 12.3 (9) yet as i have a problem with vpn tunnels not coming up.I have upgraded from 12.3 (3a) which works fine but since the upgrade i have to allow full access on my external interface.Does anyone know if changes have been made on later releases to...

Can anyone tell me how to make email a lower priority that telnet on a cisco 1760 router.

Does anyone know if you can setup isdn backup on a cisco router ( bri )to only backup during daytime ie 9-5 etc.??

Greetings Can anyone advise me on why i get configuration buffer full when i do a wri mem and how i can increase the size ??

thanks i will try and let you know.

i am trying to configure frame relay on a cisco 2600 series router.Any sample configurations would be very helpful.

Can anyone help?? When i boot my pc (w2k proffesional) i get anerror message saying requestd.exe has errors and couldnt start.... can anyone point me in the right direction please.

I am trying to load HP Openview 6.2 onto a new pc with the following results.I get 2 errors,the first is ovrequestd.exe is not running due to errors and alos when i try to put in the liciense i get an error that jrew.exe also has an error.On top of all that the alarm browser doesnt work.Would...

I am trying to configure a cisco 831 using pppoe.Am trying to setup a VPN tunnel and the local isp has given me a user-id and password. Have looked at the cisco web site but see nothing to show where the user id and password should be in the configuration??Any help would be appreciated.

Can anyone tell me if there are any known compatabilty problems between cisco routers and nortel/bay 450t-switches.????

Help??? I cant get isdn backup working between 2 cisco routers.The remote cisco 1760 is dialing out ok but the central site cisco 2600 ( which is used solely for isdn backup )will not answer.The 2600 has a primary rate installed 1Ce1B.Does anyone have a configuration i can look at???

i am trying to upgrade the ios on a cisco 3725 from 12.2 to 12.3 but get an error message saying "not enough space".What i thought would happen is tthe old image would be deleted before the new one would load.Any idea's???