Recent content by jtabet

Yep, identical.

I have a communication manager configured to send CDR to a PC. Upon receiving the information my software is parsing it as Hexadecimal. This is the first time that this kind of behavior happens to me. my software is working fine with other communication manager, any Idea what might be the problem?

has any one isntalled MM5.1 on a widows server 2008 machine? do we need a special procedure to update the schema of the 2008 AD?

Hello, Can anyone help in here?

Hello, has any one isntalled mm5.2 on a widows server 2008 machine? do we need a special procedure to update the schema of the 2008 AD?

Hello, I have the same scenario, but I am still working on the design. What type of trunk card did you use from the Avaya side. Can you please send me the hardware configuration of your PABX.

Where can I read on H323 fixups, do you have any particular websites

We have tested on digital and analog handset. I will check on Monday the config to see if direct media path is enabled or not. the weird issue is that the problem is happening on a random basis. According to my knowledge in a H.323 phone call the signaling goes on port 1719 1720 and the voice...

Dear All, We have an IP406 connected to a Small office on a wan network. The routers used are HP ProCurve 7102. The problem i am describing below has happened at the customer site and at the lab where we were able simulates the WAN setup. We are using NAT on the router, application layer gateway...

What I need to know if someone has already faced this kind of problem.

Dear All, We have installed a IPO 406 on a client site. The client have only digital phones and recording is enabled on all phones. The client uses Contact Store to hear back the recordings. Initially we had some noise when calling, by luck, we reinstalled voice mail and contact store on another...

I have already upgraded, I want to know if somebody encountered this problem before.

Delta server version is 5.2.16.

IP office version 3.2.55 I will get the delta server version when I get to the office.

I am trying to connect a 6200yl to an avaya G7000. The 6200yl has the latest firmware, the 1000 baseT port is configured to work as a 100Mbps. when I connect the avaya gateway the link doesn't go up. other devices operating at a speed of 100Mbps are working. any ideas?