Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jrmann1999

  1. jrmann1999

    9608 losing call history

    I have a single user with a 9608 that will just stop logging calls into history. Doing a craft clear restores the functionality for about 2-3 hours, then it just stops again. User is high volume, but so are plenty of others, any ideas? We have swapped out the phones and are getting the same...
  2. jrmann1999

    SMTP Relay

    Using Avaya CM Messaging, I've attempted setting up SMTP relay of voicemail off the system with no luck. I have defined my smtp relay in Server Administration->External Hosts. I then added selected that host in the dropdown under Mailbox Gateway Machine Name within the IMAP/SMTP...
  3. jrmann1999

    1841 Question

    Is there any way to use one of the IP addresses(that's not the Serial) as the source for crypto?
  4. jrmann1999

    1841 Question

    I'm trying to wrap my head around something: I have an 1841 with T1 WIC, Wireless 802.11g WIC, and two FA interfaces. T1 WIC gets a serial IP from AT&T I want to Bridge the wireless WIC and one of the FA interfaces(FA0/1). FA 0/0 is connected to a DSL modem I'm getting a /29 of public IP...
  5. jrmann1999

    ASA VPN Disconnections

    Solved my own issue, the far end routers(1800 series) were rekeying every 3600 seconds. The ASA profile was set to 28800 seconds, but the far end routers overrode it(Debugging on the ASA helped with this) IN my VPN profile I reset the keying to 28800 on the far end 1800 series routers and now...
  6. jrmann1999

    ASA VPN Disconnections

    I have about 25 offices setup with Site-to-Site tunnels to a Cisco ASA 5510. The 25 offices use mainly 1800 series routers(1811W mostly). Every office experiences multiple disconnects every day, where the VPN appears to drop and restart instantaneously. Each location runs Citrix to a server...
  7. jrmann1999

    Router Ordering

    I need advise on the best setup. I have an ASA and a traditional 1841 router. My 1841 currently terminates all VPN tunnels(about 30 so far). Both devices sit on my corporate network. Should I make the gateway for my corporate machines my ASA, which then forwards to the 1841, or vice versa...
  8. jrmann1999

    OSPF Question

    excellent! reverse-route works exactly as I wanted.
  9. jrmann1999

    OSPF Question

    probably not since I have no clue what that is.
  10. jrmann1999

    OSPF Question

    If I issue sh ip route On the 2600, I get only routes I have defined in the config, none of the VPN tunnels show up. Those static routes to redistribute. I've never considered adding a ranged route, just curious if this was even possible.
  11. jrmann1999

    OSPF Question

    Can OSPF be setup to redistribute IPSEC routes? I have a 2600 that terminates 20-25 tunnels. IP addresses behind each are 192.168.1.0, 192.168.2.0, 3.0, 4.0, etc etc. I'd like to use OSPF to advertise these to my ASA that sits on the same network as the 2600 so I don't have to static map...
  12. jrmann1999

    Reflective ACL (Return Traffic)

    I have an ASA 5520, need some advise. Three interfaces are setup, inside, DMZ, and outside. The three above have the following security(in order) 100, 50, 0 As I understand it, inside can talk to all interfaces without any ACL logic(yes I have the option enabled for same level traffic). I'm...
  13. jrmann1999

    Netbios NAT or Drop

    I have an ASA box that is constantly sending me the following errors: <163>%ASA-3-305005: No translation group found for udp src outside:192.168.200.3/138 dst outside:192.168.200.255/138 <163>%ASA-3-305005: No translation group found for udp src outside:192.168.200.3/137 dst...
  14. jrmann1999

    Netbios NAT

    I configured this beast with the ASDM utility, so if it's wrong blame cisco's confusing tools. ciscoasa# sh running-config : Saved : ASA Version 7.2(2) ! hostname ciscoasa domain-name txhmg.com names dns-guard ! interface Ethernet0/0 nameif inside security-level 100 ip address 192.168.1.222...
  15. jrmann1999

    Netbios NAT

    Ideally I'd like to redirect this request to another subnet, or block it. The VPN clients are setup to get a fixed WINS server so this broadcast request is redundant.
See more

Part and Inventory Search

Back
Top