Recent content by JPJacobson

I've read the other post, but have not seen an actual meaning of what the Event Data 1 and 2 refer too. Event Event Event Event First Last Evnt Type Description Data 1 Data 2 Occur Occur Cnt 3706 No VOIP Resource...

Has anyone seen this message. This is happening on 9620 IP phones that are on firmware 3.17b. Its at a small site with 10 phones. Just out of the blue the phone will popup with the Authentication failed.., press cancel to continue. Pressing cancel the phone comes back to the extension list and...

As the number of subscribers on our MM 5.2 system has grown past 5000, we now get the message that the Maximum number of filtered subscribers allowed: 5000 popup when you click on Manage on the Manage Subscriber screen. Is it possible to increase the limit? We have a third party assisting with...

Add an entry in the ARS all table for 01133 and use Deny in the Route Pattern field.

The easiest way is to telnet to your CMS server. Login as the “cms” user to get to the Unix prompt. If you want to know what users have been logging in to the CMS Supervisor, you can use the “last” command. To get a list of all users on CMS you can do a “cat /etc/passwd”. I use Procomm and the...

Has anyone seen this before? We're used this procedure to copy a new release to copy our server. Manage Software, select Copy a release to the local hard drive, but do not install it. Use the Copy from URL HTTP://IP/Releases It starts coping the files and then errors out. 13:30:21 |...

dwalin, Thanks for your response. What I’m looking to do is pass a variable (Vector or VDN) when the call interflows to the other center. What I’m hoping to do is reduce the number of BSR plans we need to build. What we do is scrape the callers NPA and route them to a VDN to report X number of...

CM is 5.1 with IP trunks between the two sites

Does anyone know if it is possible to pass a VDN or Vector variable when doing a BSR to another location? We’re trying to think of a way to pass something across with the call so we can route it on the other end without having to have so many BSR plans. Thoughts? Thanks

Answered my own question. On the station that the bridge appears on. It works, thanks again.

Thanks phoneguy55, That would be on the phone that has the bridged extension? Not the bridged extension itself.

We have a bridged analog line on three IP phone. When they try to transfer, they do not hear any dial tone. I see the following denial event on a station trace. 12:20:59 conf/tran hold station 574857 cid 0x274d 12:20:59 denial event 1644: Orig block/invalid digits D1=0x817c...

That’s one of the issues we have with MM. You can use mailbox manager (comes with MM) to filter the subscribers on educator state = new. That will get you mailboxes that no one has logged in to. Our implantation of MM only allows us to keep about three days of user stats. We’re working on...

How about something like this. 01 collect 5 digits after announcement 551234 for B 02 set A = none ADD 7 03 set digits = A ADD B 04 route-to digits with coverage n The # really would work if the digit length can change. You'll have to wait until...

Try doing a busy and release of the phone extension.