Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by johnven

  1. johnven

    exchange and Unified Messaging + mitel 3300 ICP + non-SIP phones

    If your looking for a maintainer Bailey's are not to bad.
  2. johnven

    MITEL Hard Drives

    Got it to work with the seagate (it was the slave/master pin) all looks ok and going to install it in a system and see what happens.
  3. johnven

    MITEL Hard Drives

    Got 1 done old mitel disk fine the other is a 80Gb Seagate gets to boot device : motfcc unit number : 0 processor number : 0 host name : bootHost file name : Boot_Install inet on ethernet (e) : 10.7.160.48:fffffc00 host inet (h) : 10.7.160.65...
  4. johnven

    MITEL Hard Drives

    Sorted it, network issue. Long week :(
  5. johnven

    MITEL Hard Drives

    Trying what kwbMitel said and not working, attaching the boot process: MITEL SYSTEM ROM R2.3/9 Nov 29 2007 (103) CCA Number : 56005084 RC.7 System Model : 004f0002 F64 CPU Model : 8270 R0a10 Reset Config : 04043246 Bus Clock (MHz) : 66 CPM Clock (MHz) ...
  6. johnven

    Backing up RAD greetings

    Thanks for your help, get the boss off my back :)
  7. johnven

    Backing up RAD greetings

    Hi When you back up the 3300 with voicemail, it keeps the mailbox and RAD greetings. Where in the .tar file can i find them. Need to prove it to the management. Thanks
  8. johnven

    Using # in extenstion number

    It's an MXe and connected via the first port
  9. johnven

    Using # in extenstion number

    10:42:54 Call Control - Maintenance Maintenance: Category(General); msgFormatId(0)Restart information from hardware status register was power up 10:42:54 Call Control - Software LOGSYSRTR is ready to route entries Log name: maintenance 10:42:54 Call Control - Software LOGSYSRTR is ready to...
  10. johnven

    Using # in extenstion number

    Not on auto reboot ATM, can see where it's been rebooted. Cannot see ServiceOverLord.
  11. johnven

    Using # in extenstion number

    Exported the logs and cannot find that in them.
  12. johnven

    Using # in extenstion number

    Yes every day last week it happened, took out the #xxxx ext's and now ok. Have put some back to see if i could replicate it but ok now.
  13. johnven

    Using # in extenstion number

    Copy of the DBMS Check: DBMS info: Lab Default DB is off DBMS CHECK has commenced. DBMS info: DBMS_INITIALIZED is on DBMS info: Journal is on...
  14. johnven

    Using # in extenstion number

    Get the following after doing a DBMS Client: DBMS Info: Current database client list: dbvcheck is a reader
  15. johnven

    Using # in extenstion number

    Thanks for that, knew it 'could' be used, but wasn't sure if it caused any problems. Specially with the end of dialing character. We are getting the DBMS check starting in the morning and completing, but then the database is locked out until the next reboot. Trying to think of what might be...
See more

Part and Inventory Search

Back
Top