Recent content by johnpoole

build a new one and take all the defaults.. put a number on key 0 DES YOUS TN 252 0 15 01 VIRTUAL TYPE 2210 CDEN 8D CTYP XDLC CUST 0 NUID NHTN CFG_ZONE 153 CUR_ZONE 153 ERL 0 ECL 0 FDN TGAR 1 LDN NO NCOS 0 SGRP 0 RNPG 0 SCI 0 SSU XLST SCPW CLS CTD FBD WTA LPR MTD FND HTD...

D000 ld 32 NPR000 .conv 34ab => 052 0 10 11 .conv 933f => 144 1 15 19 john poole bellsouth business columbia,sc

you even remember what a 51a lamp is.. you think Cisco would be better if they had one eng that knew what an A lead was.. you remember when you upgraded your dumb term's to 300 baud... and yes i still use **** in cisco routers... it doesn't work..and you have already retired... twice john...

almost impossible to be anything other then layer one.. if it was a power supply it would be all analogs.. it could be two bad ports.. but the same problem on two cards. at the same time.. in 30 plus years i have never replaced a card due to dropped calls... john poole bellsouth business...

i would remove a few at a time to see if any of them cause problems... john poole bellsouth business columbia,sc

no john poole bellsouth business columbia,sc

what rls? is the time right in ld 2? ttad if so turn on lamp audit, if not read the commands in ld 2 to adgust the time during midn.. john poole bellsouth business columbia,sc

wrong use of the cutover command.. use scpu john poole bellsouth business columbia,sc

quick answer.... no. john poole bellsouth business columbia,sc

nortel made a box for home use. it did a basic dial in then enabled a digital set at home... it's been 10 years and voice over killed the app but look in that direction... i would price fiber to the new area and add a remote cab.. any solution is going to add to the budget... fiber remote or...

log into the server itself and look at your drives.. john poole bellsouth business columbia,sc

turn on lamp audit or add a key to your phone to turn each one off john poole bellsouth business columbia,sc

read the manual.. after the feature code dial the scpw of the set john poole bellsouth business columbia,sc

sounds like a bad hk switch, doing a flash as it hangs up.. if it is system wide it it a timer... years back we added ftr phd to each set to stop perm hold.. simular to what you have described... perm hold does the same thing IF the far end hangs up... john poole bellsouth business columbia,sc

didn't read any of the replies... red alarm is no layer one between you and the far end... unplug a cable on any t, it goes red... from the back of the switch put a loop back toward the switch... if red goes yellow. move the loop back to the next connection... nothing you do in software can...