Recent content by joelunchpail

Thank you I just got a new Monitor today. If I find a few more cords I will setup both systems side by side and begin transferring what I can. With a few usb extension cables I can swap my key board and mouse back and forth without to much rigamarole. Not a lot of room on my desk. The other...

I have a USB USRobotics Modem that I am using at the moment still on my old XP. I don't know if that would make a difference on hang up. I don't require running scripts mostly just a few Adds, Moves, & Changes. Is ZOC a better solution for my problem? Great Web page! Thank you

I've been away from this forum for quite a while but I have a problem that I hope someone here can help me with. I have recently purchased a newer computer with Windows 10 and am in the process of getting all of my old programs working on it. I have Procomm Plus 2.1 from 1995 running on XP on my...

What range are you looking for usually you only require a dn in a limited range eg 1600 to 1699 or 1400 t0 1499 in that case you can put in the range after DN eg 16 or 14 . if you leave that blank it gives all available numbers to save space it it prints numbers like 10 meaning every number...

Is there any way to have the trunk status displayed on a fractional PRI On the old analog trunks a line pool key would display when all trunks in a pool were busy I have a customer whose PRI probably requires more trunks enabled but it is hard to confirm that is what is causing the problem...

probably newer than 4.1 s/w its a NVRAM Rls 2 cartridge dated 2000 almost 2001 i guess the s/w could be older but I would would bet a doughnut it is 4.1 or later.

(1 Norstar Flash (all I can tell about this so far is the box simply says norstar flash on it. I have not investigated this much yet) This is your voice mail unit and your Auto Attendant 24 mailboxes plus general delivery and system manager "with about 18 phones and 8 Copper lines attached for...

I usually write the PRI code on the inside of the door so i don't loose it in case it gets lost in programming I have had to re install one before

I took a look at the existing programming and the Main Number is in ring group2 and night service sends it to the Call Pilot Local Manually at whenever time they close (Quick and dirty.) I had a talk with the Manager and he is looking for flexibility and wants to share the responsibility of...

do you know what the old SYS ID was or did you try the original PRI code Do you know if the System ID did change or only the programming was lost it might help determine which CAPACITOR is bad

what you really need is a new carrier

the main number is a hunt group so yes forwarding the hunt group would work or a set that the HG appears on or the DID target Line of the main number. Whichever way you think is the best.

All incoming calls to the big box store that come in after hours till 9:00 PM to be sent to his cell phone. I know it Sounds like incredible dedication but that is what the request is. right now they get the AA with an after hours greeting and store hours

I think the only elevator phones i installed were a hot phone dialing the elevator company emergency number i

I have a customer who would like calls from 6:00 pm till 9:00 pm to go to his cell phone and after that to the auto attendant. I think the simple solution is two automatic timers and one phone that that normally does not ring that is programmed to transfer to his cell phone. At the moment His...