Recent content by jkeeper

Hello!! I would like to know of (low cost)tools that will allow me to remotely manage switchs and routers config files. Try to cut down on travel but still be able to manage devices. -Thanks -JKeeper

I have a copy of the Cisco "Troubleshooting Cisco Catalyst Switxhes to NIC Compatibility Issues. "Does anyone have a copy of, or know where I can access a copy of Microsoft's tech sheet referering to the same nic issues? Thank you!!

Thanks for your reply. We were able to recover the pastword and we did have to recover the configuration. -James

I think If I change the Supervisor on the 6509 I can reset it up (config ). Can anyone tell me how to do that? -James

I did a password recovery on the 6509 and now it does not see blades 5,6,7. another error message below: invalid feature index set and the status light for each of those blades. Has anyone any knowledge of this problem. -James

I am looking for a good monitoring tool for SQL. Does any one know of a few good products? I want to be able to see inside of SQL and how it processes its transanctions and errors. Thanks

Where can i find more information about IRIS? Jkeeper

I think, you can get Sniffer Reporter "Now" for $500.00 when you purchase Sniffer Pro 4.5 it was sold for $7,500 And yes you can get it as a package deal. You must ask for the questions before you buy. Jkeeper

I am using Sniffer 4.5. I am spaning a single port but I want to exclued http traffic. How can I do this? -James

OH yes! We are 97% Cisco and Windows NT 4.0 / some WIN 2000. James is Jkeeper

No replys, hummmmmmmm? Jkeeper

OK, here is the deal, This remote location had two T1's, had, and since one has been removed the users are screaming that they need the other T1. It was removed for cost reasons. The T1 connects to a 3810 which connects to a 2900 switch. I have to monitor the traffic to see if it can be...

Thanks for the quick reply, now do you have any suggestions of tools or where to look for them? -James

What is the best way to test or measure your network bandwith. Should I use a Sniffer, where do I start. What is wanted is how much bandwith is being used at a remote location.? -James

Hello, Is it possible to Sniff a 3810 and how different is it from Sniffing a switch? Thanks JKeeper