Recent content by jimmy13

I have an HP 2000c color printer running off a W2K server. All works fine but suddenly the optional tray isn't detected when printing from any PC on the network. However, printing a test page by holding down the power button on the printer, it will pick up paper from the optional tray. Any ideas...

I don't think i can check to see whether its running as a service, because im running W98se, which doesnt have services.

When booting a laptop, i have to log into the domain, wait until the us robotics utility starts then i have to log off and on again to get the user scripts to run. Does anyone know any work around for this problem? Thanks in advance.

If you say the data wasn't important, did you format the disc before trying to install XP??...if so what did you use to format it and using what file system?

I have a PalmIIIe trying to sync with lotus notes files using Easysync 4.2 When specifying the location were the mail file is located, it doesnt detect the server. Ive done the exact setup on another PC and the server is detected. Any ideas what it can be? Thanks in advance. Jimmy.

HP 1300n great little printer with workload of up to 10000 pages/month.

You can use the Jet Admin software to set the IP address. If you dont have it already installed it should have come with your printer.

I solved this one...It was in fact the toner cartridge that was at fault.

Hi, I have an HP960c and it seems to be printing very lightly(only black ink) colour is fine. I just replaced the ink cartridges for both the colour and black ink. The first test page seems fine but about 2 days later i started having this problem. Any suggestions?? Thanks in advance.

When trying to print from the manual feed. The paper goes through about 3inch. Then gets stuck. I noticed that if i push the paper in a bit, it wont get stuck. Any ideas on what i can try to solve this??

HP 2000 Prints good color images for an inkjet.

I have a HP 6L laser printer. it doesn't seem to feed any paper. i looked inside and the rollers arn't even turning. Anyone have any ideas??

I use arcserve 2000 for backup. my friday backup uses 2 tapes. My problem is, if i don't erase both tapes before, it won't accept the 2nd tape when propted. Does anyone have a solution to this? other than erasing the tapes before begining the backup.

It stay's visible in your inbox, untill you click on the refresh button, then it should only be in your trash folder. I havn't come across any way to get around this.

I Keep getting this message when opening notes minder. "Error Updating ID file Internal error, a required parameter in a subroutine call has not been supplied." Does anyone know what this means?? Any Ideas how to solve it??