Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MikeeOK on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by jessiedog
-
Phaser 350 stuck in warmup cycle
Dany thanks for the response. Unfortunately, my printer will stay in warmup all day if I let it. I don't think the heater is bad because it works great when I first start the printer, only going bad after I let it go to standby. Also, I thought the front door close sensor was located on the...- jessiedog
- Post #3
- Forum: Printers General Discussion
-
Phaser 350 stuck in warmup cycle
Hi All: I have a phaser 350 printer that works great when it is initially started up. It goes through the warmup cycle fine and prints a perfect cleaning page. After the printer sits unused for a while and goes into standby and then it gets stuck in the warmup ??% cycle when trying to use it...- jessiedog
- Thread
- Replies: 3
- Forum: Printers General Discussion
