Recent content by JBalzer

Oh yeah, HAWKS I did try to DISABLE AND ENABLE the card. NO GO. When I put the working CI in I did notice the "CLICK" noise but not for the non woking card. Cheers... JIM

Hi this CI card is a bit older, I believe it has a date of aprox. 2000. I did leave it powered up for a long time (like overnight) it didn't register. I pulled a newer, working CI card from a MICS and it came up fine, so it looks like a component decided to give up. I reset the CICS by shorting...

Thanks every one for your suggestions, Sorry I took so long to reply. It looks like I need to try a new CI Card. Thanks Again Jim

I have an older CICS (late 90s came with DR2). I have upgraded it to 7.0, it has one CI Trunk Card and 16 DNs. I had it siting unplugged for a few years. It seemed to come up fine. I hooked up a couple of T7316Es and a Call Pilot 100 all works fine except no lines available. I have programed...

I am considering installing 4.11 on a Compaq CL380. There are 2 servers in this arangement that share hard drives. 1. Does Netware 4.11 work on a Cluster server? 2. Does this require 2 licenses? Thanks Jim

Can anyone recommend a Digital Audio Logging device that can record all calls on 8-12 analog phone lines?

JERRYREEVE, That's a neat idea(PA plugged into the headset jack). I have a few 7208s with dead LCDs, they would work for that. So, how does the Overhead ringer idea work? Does the headset jack broadcast rings and pages? JB

CURLYCORD, So far I haven't added a PA system, But that, or the self amplified speakers would work. I might just change the Page zones so our office is Zone 1, 2 or 3 JERRYREEVE, It’s a Norstar Door Phone, It only has 1 Button, The MICS sees it as a 7208 set, The programming is...

Oops! In my previous reply I stated that the Norstar Door Phone pages PAGE ZONE 1, 2, 3 and plays a chime. It should have read, that it pages Zone 1, 2 OR 3 (not all) (it can also be set to none) JB

Just a thought ... A Norstar Door Phone is set up to call a particular set, if that set is not answered within a certain number of rings it then pages PAGE ZONE 1, 2, 3 and plays a chime. If you play music (feature 86) over your phone system and the music source output volume is set quite...

We have recently set up a new MICS 6.0 phone system at my work. We Presently have 4 buildings on our site, we refer to our shop and warehouse buildings by Building 1, Building 2, and Building 3 (The sequence in which they were built) I’ve also assigned them Page zones 1, 2 & 3. Since Norstar...

Arr/PhM Why am I beating this to death? The fax traffic between buildings is way to light to worry about using 2 trunks once in a while. Thanks Again JB

Arr/Phm Thanks... After I read MRoberts reply I went ahead and ordered a 4 line distinct ring detector. I had previously ordered a LS/DS for this purpose and we had extra ASM ports left over. I figure that this extra hardware for this fax system will be paid for in 9 months and then we will...

We have a MICS 6.0 System with several ASM ports available. Our incoming fax volume is relatively low and only justifies one incoming trunk line, but for a minimal monthly charge our TELCO offers IDENT-A-CALL (which one analog line can have up to 3 additional phone numbers, each with it’s own...

Thanks for your input everyone. I was hoping to be able to put this old unit back into service. I'm sure the software upgrade will be much less than a new VM... thanks again JB