Recent content by jaze

Just a single pair line cord will do it, plug one end into your spare line port and the other end into your spare ext. port.

If you have a spare line port and a spare ext. port you could loop the 2 together with a line cord and then add the spare ext. port to your calling group. Program a line (spare line port #) button on the exts. that need the light and then turn off the ringing for that line, so when the calling...

I do believe you can install a digital phone from a partner system as far out as 1000' and a analog device at 1500' do not hold this to me but I am pretty sure that is the limitations for the distance on a partner system. The limitations to a data wire is 328' including the patch cords on both...

Try the Engineus line, I have installed a lot of these and they work great with the partner system! They have incredible range with the high gain antenna and you can tie them to an ext. so when the ext. rings so does the cordless handset.

It sounds like you set up selector code # 2 to do a centrex transfer, this is alright if you do not need your autoattendant to transfer to any ext. that starts with a 2, if you need that you may want to use selector code #5 or higher and set selector code 2 back to direct ext. dial. I think the...

The phone type is a Partner 6 Button display, this is very odd I have never seen this problem before.

Customer has Partner R.7 ACS with Partner Messaging, they have a ext. phone that continues to beep, I found in the program that line 8 was assignned to this phone and this customer does not have a line 8. I tried to un-assign line 8 for that ext. with #301 it shows it is un-assign, but when you...

Have a customer that has Partner ACS R.7 w/308 exp. card and Partner Messaging R.7. I have setup dial 0/timeout action to call a calling group with several exts. in group. Works fine but customer wants to be able to distinguish between a dial 0 call be transfered by AA and someone just...

Selector codes are used for many different things, you can have them point to a specific ext. or groups, you can have them point to a mailbox, you can have them do a centrex transfer, you can have them point to submenu's,but if your vm is answering your calls and the caller is transfering...

Can someone tell me the method to test a MLX 20L with a DSS, I am trying to rule out burnt out LED's. Thanks, Joe

Yes you have to program the personal speed dial's at each individual ext., the speed dial #'s are 80 to 99. To program at the ext. you need to hit feature 00 then feature 80 for the 1st speed dial and then enter the number you wish to speed dial, then you can either hit feature 81 to enter...

Have a customer that has a Partner ACS R.7 with Partner Messaging R.7 and one of the users lost all their messages from their mailbox. Some of the messages were upto 6 months old and I was wondering if there was a shelf life for listened to messages. Any help would be greatly appretiated.

ken1713 they are paging threw their handsets and I actually just took another call from this client and it is starting to happen on more exts. in the system. So I am probably going to make a sight visit to try to resolve this issue - so any tips I could try would be very helpful.

Have a customer with Partner ACS R 3 in a 5 slot carrier with a 206E module and a AT&T page pac. Every time they over head page from a couple of exts. the speakers squels threw out the warehouse, there was a speaker close to one of the ext. so my first thought was feedback from this speaker so I...

psmit - I have the exact same situation. I have a system tied to a closure system that is a normally closed circuit. Can you please send me the same diagram as well?? Is there a way to configure the IP Office system to be in a normally closed state as opposed to open? Any help would be...