Recent content by jayg9999

How do I go about settimg coverage and how wouold I assign it to the 8 phones?

I have a Merlin legend R7 iwth a PRI. I want to have an inbound call that comes in on a specific DID ring at multiple phones. If this can be done, what are the restriction regarding number of phones and number of simultanious calls

There is also some software called Call Accounting from Commone. Their website is www.commone.com. I bought mine on ebay a few years ago and is was not expensive. I have had very few problems with it and their support is very good and fast

Thankx.

My system is running hybrid/PBX and and some of the ext operate like a key system, 8 lines on a MLX-28 configured as line appearance. I want to program the managers phones so if they pick up a line, no one else can listen in by picking up the same line on their phone

Thankx!!

and then is it primary or secondary?

OK, starting to program the extenion. For the coverage button, is it: Coverage CoverageOff CoverageVMS CoverInside

THANKX!!!! didn't see that option before

Thanks,. this may be a silly question, but how do you get into centralized programming. I have WinSPM as well as a 20L

Thanks Merlinman, just one ,more question, how do you assign a button you can not see? (34)

There is no real extension. any other thoughts?

is there a way that I can have an phone with both an existing ext number (101) and also add a DID from my DID pool (239 -259). I have a MLX-28 and for part of opur business we have 8 POTS lines set up as line appearance on individule buttone. I would like to add an incoming line as a direct line...

What about a 016 Tip ring card? Will it work completely with CKE3 R7 Legend?

I have a CKE3 running 7 14.2. I dont need the full 16b ports, at most 8-10 plus a fax or 2