Recent content by jamin123

My MB manual said to check that the card is seated well and that was exactly the problem. Thanks.

I have a soyo board with 1 AGP port. Should it not show up in Device Manager, System Device? I insalled a new RADEON 7000 card in W2K and new hardware isn't detected. The video manual said non Intel board needs a Virtual GART (AGP)driver. I can't find any GART driver at Soyo site. I was using...

Thanks. Bistar did suggest I get a controller.

I send Biostar an email and they claimed I need to upgrade my board because they don't have a BIOS upgrade.

It hangs as soon as the drive is detected on the line that reads some thing like master hard drive " LBA, UHMS 2, ." When I boot with a small drive that line completed as "LBA, UHMS 2000000" but in the case of the 160G it hangs. I have a later model motherboard w/800 processor runing 2Kserver...

I use Win Advance server Disk M. to create 4 partitions of 40Gs and 20Gs for dual boot with XP, Linux and 2K. I'm unable to install any OS because I can't get the system to pass the BIOS check. My Biostar M5SAA motherboard has not put out a BIOS update since 2000, so I may need a new board. I...

I fixed the jumber problem and the drive was detected. The problem now is it doesn't see the size at all, so the system hang before it get to the operating system.

Thanks. I'll try that when I get home.

I want to replace my 20G hard drive with a 160G, but the Bios doesn't detect the new hard drive. I can't find a Bios upgade for Biosta M5SAA motherboard. I ran out of ideas to try.

Thanks. I did re-service pack, but that didn't help. If I reinstalled with formating the drive I may not lose the data, I think.

W2K is booting in Save Mode. If I run setup.exe from 2K OS disk will I lose all my data folder on c:\? I'm not concern about losing applications. The problem is that I don't have another drive to back some folder which store data on c:\. I stated have problem after download MS new antspware. I...

Can any one recommend a decent WIRELESS AUDIO/VIDEO SENDER? I want to transmitt from my computer to other rooms.

Divide your VC by your bandwith to config bandwith on the interface. Use frame-relay route for Dyhamic or frame-relay ip map for static to map layer 2 DLCI to the layer 3 IP.

Thanks guys, I like the Linksys WRT54G. What model Netgear are you using, Plshlpme?

I've several Cisco router on my home lab, but I want to add wirless capabilites for my kids computer. I'm confuse with all the different wireless routers. I need a wireless router that can do wireless, usb and work with my exesiting wired network. I dont want to spend too much on this router...