Recent content by jamesc0

Hello, I have added memory to several Phaser 740s. The memory must be PC100 SDRAM. PC 133 will not work. Also I doubt if server memory will work. I have some here and will try it in the morning. Also the slots will only take a max of 128mb in each slot. As has been said before, print out a...

Hi Cyclone27, This thread is a year old, and I have settled on a 6200c which works fine, including the Auto Doc Feeder. Thanks for your interest. Rgds, James

Hi, I have a Phaser 740 with a SCSI hard drive. I will try to answer your questions. 1) The drive is probably faulty. However you could try reformatting it. To do that go to the xerox site and find the 740 downloads. Dowwnload the utility files which are in postscript format. Download and...

Hi, Thanks for your reply. My 6100c is connected via scsi port and works fine. I know the 6200c also works. I wanted to know if a 6300c would work. In the end I tried one and it didn't! Thanks anyway, James

Hi all, Just had the phone bill. The ISDN adapter has been dialling up the internet about once a week and staying on for anything up to 12 hours! Rushed over to the computer and found it was apparently disconnected. The taskbar Icon wasn't there and in Network connections it's status was...

Which printer?

Silvia - no I didn´t. There are several differences. Marcs41 - This looks very helpful. I will try it this weekend and get back to you. Thank you both for your responses.

Hello all, I am trying to recover mailbox stores from a windows backup. The backup was from a server running server 2003 and exchange 2003. The server has had server2003 and exchange2003 re-installed. I have now got as far as mounting the mailboxes into a "Recovery Storage Group" in exchange...

22,722, 0C DECLARED JAM Media jam at stripper fingers Regards, James

Hello all, I am trying to recover mailbox stores from a windows backup. The backup was from a server running server 2003 and exchange 2003. The server has had server2003 and exchange2003 re-installed. I have now got as far as mounting the mailboxes into a "Recovery Storage Group" in exchange...

Hello all, I am trying to recover mailbox stores from a windows backup. The backup was from a server running server 2003 and exchange 2003. The server has had server2003 and exchange2003 re-installed. I have now got as far as mounting the mailboxes into a "Recovery Storage Group" in exchange...

Hi Marty5261, I have been trying to upgrade the eng firmware on my 740 to version 24 but can't find a chip. Can you help please? Thanks, James

Hi GuillermoS, Any luck with the Phaser 740 engine boards? Thanks, James

Hello Scott, Here is the entry from the manual: 31,003.4x MP_FAULT_PREHEAT_ EXIT_SENSOR_BAD Declared at boot time when a check is made to determine the condition of the preheat exit sensor. Declared when the sensors around the preheat exit sensor indicate the presence or absence of media...

Hello, I would like to upgrade the engine board firmware to version 24. The Xerox part number is: 163-1307-02. Can anyone help me achieve this please? Thanks, James