Recent content by jakesnake

the IP address should be 192.168.2.1 on the second router, sorry for the screw up

I current have it connected this way. I connect the wireless -B router BEFw11s4 to my wired router, I used the uplink from the wired router to the wireless. I also change the IP address on the wireless router to 192.169.1.151 , this way I could alway access it also. I connected the wusb11...

Did you have another antivirus program installed when you installed Norton? If you did you need to uninstall all antivirus programs at this time and all of Norton. Now install Norton again without other antivirus programs on the system. Run Live update and all should work. Note!!! when u...

I would take a hard look at the software side . autoexe.bat and config.sys to see if something was tell the system to reboot. You could rem out lines in these that you don't really need. If your running 98> run msconfig and uncheck items in the startup (autoexe/config.sys) until you uncover...

If you can use your programs then you can get to your c: drive correct? If you can go to the following folder : C:\WINDOWS\SYSTEM\RESTORE\ and double click on rstrui.exe ( this windows restore program) now it may will be in another folder in XP, but this is it in ME. You want to restore your...

wf71 Have you shut it down and restarted? That should remove it from safe mode and startup in normal mode. Oh by the way I use F8 to get to safe mode on my winME system also folks.

Scandalbeater , Do not try and run mscongig it's spelled wrong. Unless you know what your doing I would not try and shut down programs which load at startup. They (most of them) are required for your system to run. Talk to a computer greek friend who knows about running msconfig on your...

Do u know the ip address of the hub your ping? u may need to set up that IP address in your TCP/IP in the network. Also u may need to set the gateway ip also.

also you need to assign a name to the workgroup which needs to be the same for all computor on the LAN, then each computer need a name, now make sure you have TCP and micrsoft family network loaded under network in control panel. Load also IPX which is required for some LAN games, also make sure...

Have you just upgraded to XP? Have you added an new hardware? I would guess its because if heat if you have not done any of the above. Try taken the case cover off and run the system that way and see if it shutdown on you. If it does not then haet is the problem. If you installed XP then look at...

This cd-rom is an old type cd-rom which requires the old type drivers which must to loaded in the autobat and config.sys file at start up., its not an IDE cd-rom. I would trash the cd-rom and buy a new one for 20-30 buck at Best Buy or the likes when they are on sale.

Hi try looking at this link and you should fine what you want for the right price http://www.motherboardexpress.com/index.cfm

Do you have a winME start up disk? If you do use it and at the prompt hit number 1 which is load with cd-rom support.This should do the trick and now load winME from your cd-rom. I also copy the win directory from the cd-rom to the c drive and run setup from c:\winme directory.

I went back to my Voodoo 4500 card because of the same problem.

Try another HD as master and put this one as slave. If its runs to the c:\ then fdisk and format the slave drive. This should clear up the problem. Reinstall it as the master (change jumper pins) and it should work Good luck Shawn