Recent content by jaiello2000

we have the TN464f DS1 V10 Is there a software release where you would not need one of these cards?

I think it is version G3 R3 Version 6. You means the Circuit pack card (TN778)? If so, there is not one. Joe

Looks like we need a TN765 Processor Interface to get the D channel up on the PRI. We'll see if it works after getting that card.

Oh, we are not using the A120 CSU.

I (The Cisco) have been both user and network side as has the Avaya. About the clocking, Cisco docs say Avaya wants to provide clock. So I let them be clock. I did test both ways on the TPI pri tester. Right now, the Avaya is providing clocking. I am told the PBX version is G3si V6.

Thanks. I sent the jpegs. I cannot get the Cisco config as it is in another town. I can assure that it is OK. I have brought it up to other PBXs and it is fine. I also have a TPI PRI tester that confirms the D channel (layer 2) is not responding from the PBX. I have also poosted this on...

The Cisco side is fine. The Avaya is not bringing up the D Channel. Been through Avaya, cisco and other docs. I only have jpegs of the screens for signaling group and and ds1. Not sure if I can attach them here. Have you had to us ethe avaya cable and a120 CSU?

We have having problem getting the D channel up on the Avaya. Been through the Cisco and Avaya docs. It should work, but the D channel does not come up. We are using the TN464F card with a xover T1 cable. Has anyone done this type of config? Did you ave to use the A120 CSU and Avaya Cable...

Did you find a solution to the TN464F issue? I am having a similar problem.

Thanks, that was a thought, but I wanted folks to see the real VM number dialed. I want to avoid confusion since the VM number is a DID but the ACD would not be. There seems to be the same amount of work for an ADL and definging the message key. There does not seem to be any global way of...

OK, I worked it out using ADL. Much Thanks!

I do not know about Autodial. No button on the phone for that. Will search the Admin guide.

I have a standard NTBK48AA cable on the OPtion 11 and a standard 25 - 9 pin null modem cable. I have also used a 25/25 straight through to a 25/25 nul modem and a 25 -9 pin adapter. Of course that put my laptop three feet from the wall :) I use uppper or lower case. I think my release is...

There does not appear to be a place on the 3904/4 phones to program a hot key.

I have the PBX phones using an external IP voicemail server. I have worked out all the hard stuff, but want to have a button on the phones (3902,3,4) that they can press to go to the VM system. I am using a CDP where 29xx is forwarded to PRI and to my IP Network. I tried to configure the...