Recent content by jacobauskas

It is the software that manages,programs and administrator all pabx Hicom 300/300E/300H/Hipath 4000/Hipath 4500. Without com-win, isn´t possibile to do anything. Today, the final version is 5.0.78

Hey people, Could you check if the passport is block the packet arp request ? Give the commands arp -d / arp -a on the workstation and check this. I see a document for this and there spoke to create vlan arp, but when i will go to create by console my passport boot, and i never try...

cat6506, What is the activation key? Is a key that contains the licensas just, correct? How can I know, which is my activation key? Does date exist to expire? Does some command exist to see which my activation key is? When do I make upgrade of necessary ios to put the activation...

My Pix is Product Affected!! Thanks a lot!!!

Friends, For the second time in less than 1 month my Pix 515 version 6.2(2) crashes. PIX-515, 64 MB RAM, CPU Pentium 200 MHz,16 flash The PIx didn't answer any package and nor the console. What can be happening? Some suggestion? Processing and memory are very low. Does some exist...

I tried and IP snet zero dont work on my pp8000 with release 3.2.2.4

Friends, The default password of device manager is change. Type de password of rwa it´s ok. Don´t a bug. Thanks

All right the syslog server is ok!

Friends I have a passport 8600, and have two questions: IP subnet Zero in Passport Does the possibility exist of using the concept IP SUBNET ZERO similar to the Cisco in the passport? where can we use the net address!! How do I configure the passport to order the log messages for a...

Friends, Only the ip 192.168.0.25 accesses the passpor for administration. I have the access-police maid for the services telnet and snmp. However only the telnet works. It's a bug ? If I give the following command: config-sys-access-police - enable false SNMP works. Thanks...

Hello, I have passport 8600 in the version 3.2.2.4 and I don't get to manage with the device manager 5.5.3 as release notice. Does anybody know about some problem? In the version 3.2.1.0 it worked very well with the device manager 5.5.2 Thanks a lot Jacobauskas

Hi, The question is the same. How to configure pix firewall to pass ALL TRAFFIC to the websrerver in ther inside interface ? Wich commands i need to use to do this? Because i try if de command if you see in my configuration at the last e-mail. The webserver ip is 200.218.30.XX...

Friends, My question is easy. I have a WWW-server in my inside network and I need to configure de pix firewall do pass all traffic, any host for the OUTSIDE to INSIDE (WWW-SERVER). In my configuration, when the host outside request the WWW-server (inside), i have problems. In the...

Friends, At the interface INSIDE, i have webserver if the ip 200.218.30.XX. My configuration is: interface inside sec level 100 interface outside sec level 0 static (inside,outside) 200.218.30.XX 200.218.30.XX netmask 255.255.255.255 0 0 access-list inside_access_in permit ip host...

Hitender, the problem also happens, in that order: 1,2,6 1,2,100 1,2,4 1,2,8 It needs to be 1,2,3. Out of hist order i have problem.