Recent content by Jaakie

Do you know whether it is possible to get a Cisco voice gateway router to perform a *8 transfer connect without there being a connection to a PBX? The router is connected to a Megacomm 800 T1 PRI lines which except *8.

Can you expand on the yes to Analogue. I have a customer who had an old PBX system which connected via E&M to a cisco router. They have upgraded their PBX to a BCM 400 and have told us that they can no longer have E&M connection. What analogue interfaces does the BCM 400 support. Trunk...

Does the BCM support any analogue connections?

Hi All, We are connecting a Businessphone 250 to a Cisco router using E&M. Outgoing calls work fine but inbound calls receive a fast busy tone. The BP250 is set as continuous format A and the router is E&M type V 4-wire immediate start. Apparently there are dipswitches on the BTU-E can anyone...

Does anyone know what the cable pinouts for an Alcatel 4400 OmniPCX PRA2 T1/E1 interface card to Cisco router T1/E1 voice module are ? Thanks

Hi All, Is it possible to connect an MD110 BC8.0 TLU76/1ISDN-PRI interface as network side to a cisco 2600 series router. Alternatively what are the MD110 software levels that will work connecting to any Cisco routers. Thanks Jaakie

Is there any way to accurately measure how many call, incoming and outgoing are made on a route. From looking at the TRREP for the route I'm measuring it would appear that printouts using period =1 or period =2 shows calls that have started in one time period and ended in another, will be...

Does anyone know whether there are any issues with running antivirus software on DNA and OneBox servers. Also does anyone know the latest NT4 service pack and patches? Thanks Jaakie

Isinor, Many thanks, this is just what I needed. Do you know is it possible to download the files in anything other than Hex? Jaakie

Lancbomb, I am aware of the TRREP command but this is very slow, which is why I was looking for a faster method. Thanks anyway. Jaakie

Is it possible to download and read the TM data on the HDU. I have to remotely collect traffic recording records and enter them into spreadsheets and it is very time consuming. We don't have access to DNA so cant use PDM or PPM. Also does anyone know of any freeware that can be used with TM...

Thanks for all your replies so far. I have been through all the obvious things in relation to the extension. I even got the user to #001# to make sure there wasn't anything set on the phone. I was hoping that someone might have come across this before and have a solution. As its on a very large...

Rfpui, The system is BC11.0. and doesn't have the RACEP command. I did check RADNP for this number but it's not assigned.

I am trying to end a digital handset using KSEXE but get the message NOT ACCEPTED EXN HAS A RAC. I have checked and there is no authority code set, the site doesn't use freeseating. There are also no ADN's, SPEXI's or MDN's. Any ideas?

I need some help with programming. We have a HiCom 300 and I need to reduce the number of channels on two routes from 6 to 2 channels. Our Hicom engineer is away on holiday so not available to do the programming. The system is in a test environment. I know the basic structure of Hicom...