Recent content by ITEM

The electronics counts sticks used in the ink loader. Cut them down makes them too small to count and it keeps requesting more ink. It's not Xerox's fault when someone bypasses sensors.

Try to manually tilt the printhead. And proceed through the whole motion cycle--forward and back. Look on the left side of the machine where the big head tilt gear is. This gear has an un-toothed section that you got to rotate past, or sometimes unlock. If you can manually tilt the...

If the clutch 116-1539-00 doesn't solve it, then it probably is the Black Developer, or the ATC Sensor which is part of it. Occaissionally a bad Developer Motor or Image Drum Motor can give the same result. Whit Item, Inc.

The camshafts are a good bet 020K14800 and 008K02160. You can only verify the crack by taking them out of the chassis. Even minor cracks are a growing problem. Whit Item, Inc.

Maybe you could use the auto duplex feature, depending if that paper is supported for duplex. Whit Item, Inc.

The Xerox has an OHP Over Head Paper sensor, in the manual feeder. If that sensor is happy with your transparencies, and you are using the right settings, it may work. Buy one pack of the Xerox brand just as a control to test it. -Whit :)

There is a new style drum maintenance clutch which is recommended to fix this problem 650-4288-00. It looks very different than the old 401-0871-00. It works much better. -Whit :)

The polygon motor is part of the laser scanner assembly 116-1110-00. If you get that error code, it usually is accurate. The laser originate the image pattern, so if it doesn't work...you get nothing. It is essential to getting any print. You will need to buy a scanner, and then do Regicon...

The lower tray is probably fine. It may be the paper pick clutch 401-0808-02, which is pulling from both trays at once.

Don't worry about it. They work fine interchangeably in all cases.

I am a technician and keep running into this error on Tek 850's. I replaced the upper feed sensor 351-1106-00, and it still doesn't work. The same printer jams from the manual feed 22,411. I've changed a few other parts, like the DM clutch, but all with no fix. I have not figured this one yet.

The yellow is the only color which doesn't destroy the printhead

You need to buy the Drum Maintenance Clutch 401-0807-02. For 90% of the time that's what you'll need. We distribute parts here, so I know from experience