Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by itayemi

  1. itayemi

    How to get Sendmail to relay only to specific domains for a particular client IP

    Hi All, I have Sendmail behind a firewall which port forwards port 25 (SMTP) to the mail server. Connections from the Internet acquire the "internal" IP address of the firewall, so in all respects they are "local" My problem is that if I REJECT connections from the local IP of the firewall, then...
  2. itayemi

    CompTIA Linux+ certification objectives?

    Hi All, I am just about ready to take the CompTIA Linux+ cert exam. Checked on the Net only to find out that they are about to introduce a new 2004 cert. objective which is quite different from the old 2001 objectives. Please I need to know if they have (or when they will be) introduced the...
  3. itayemi

    clearing Netra X1 LOMlite password

    Hi All, Please I have a Netra X1 with me at the moment. It belongs to a client who cannot remember the LOMlite username and password for the box. It suddenly "stopped" working one day and the box was brought to my office. I connected to it via the ALOM port and discovered that it was...
  4. itayemi

    lost LOMlite username and password

    Hi Sirt, thanks for the link. I have tried to reset the LOM by jumpering the jumper JP13 but to no effect. Maybe I didnt go about it properly? If I put on the jumper then power the box, it doesnt come on at all -it is as if no power was supplied to the box. Ok. I then powered on the box and...
  5. itayemi

    LOM Password unknown

    Hi, There is a 2-pin jumper right next to the SmartCard if one looks at the system from the "back" with the cover off. Would yours (j13) be in around the same position? This jumper has no label - may be the circuitry didnt allow the label to show properly. Thanks. Where do I get a...
  6. itayemi

    LOM Password unknown

    Hi brs154, I have an identical problem but with a NetraX1. I can't find jumper J13 on the motherboard. I have looked everywhere but no luck. How did you arrive at the solution? Maybe I can use that as a pointer in finding what the equivalent jumper should be on the NetraX1? Also, do you...
  7. itayemi

    LOM Password unknown

    Hi brs154, I have an identical problem but with a NetraX1. I can't find jumper J13 on the motherboard. I have looked everywhere but no luck. How did you arrive at the solution? Maybe I can use that as a pointer in finding what the equivalent jumper should be on the NetraX1? Also, do you...
  8. itayemi

    lost LOMlite username and password

    Thanks a lot SamBones, but I can't find the J13 jumper on my motherboard. Also do I jumper the "jumper" with the system powered? I have looked everywhere on the board - found J19 among others but no J13 Do you know of anywhere I can find a diagram showing the locations of the...
  9. itayemi

    lost LOMlite username and password

    Hi All, Please I have a Netra X1 with me at the moment. It belongs to a client who cannot remember the LOMlite username and password for the box. It suddenly "stopped" working one day and the box was brought to my office. I connected to it via the ALOM port and discovered that it was...
  10. itayemi

    sunfire 100 network interface not coming up

    Hi AllenV, I finally fixed the box by putting the network config commands below into the /etc/rc2.d/S69inet file: ifconfig lo0 plumb ifconfig lo0 127.0.0.1 netmask 255.0.0.0 up ifconfig dmfe0 plumb ifconfig dmfe0 217.144.10.12 netmask 255.255.255.0 up route add default 217.144.10.1 It worked...
  11. itayemi

    sunfire 100 network interface not coming up

    Hi All, I have a sunfire 100 that comes up without setting up its 2 network interfaces -even lo doesnt come up at the point where it is trying to configure the interfaces, i just get the message ifconfig can not find /usr/lib/ld.so.1 killed repeated about 6 times or so. Also I noticed the file...
  12. itayemi

    DNS cache

    Hi All, I have two Linux RH7.2 systems running BIND 9.2 I noticed though that within minutes of losing my Internet Connection, the DNS servers stops resolving. Even sites that have obviously been queried before (google, cnn etc) don't resolve. What could be the problem? I work for an ISP and...
See more

Part and Inventory Search

Back
Top