Recent content by isoparts

Thanks Doz, worked like a charm! Sorry that I missed that post in my searches. Best Regards, Mike

I have an mlx-10d phone that has pool 891 (which is our fax pool) programmed on one of its buttons. The phone rings on every inbound fax call received. I would like to remove it from the phone, but I do not know how. I tried programming it a different feature, but get an error. I would just...

Hi Tom, Thanks for your response. The ES2 seems to log the user into all Calling Groups they are included in..it never asks me to enter in a default Calling Group. In reference to the voicemail rollover. I have all calls go directly to AA. From there they can prompt out to the specific...

Hello All, I cannot get a calling group set to AutoLogin to roll to voicemail. So, I set the group to AutoLogout and I am attempting to program the phone at the extension (4406D+ and MLX-5) with a Login/Logout button. I can set the button to *764 or *765, but I cannot figure out how to set...

Thanks for the update Tom. If i program a phone, say 4406D, to have a button to grab an available outside line, and then dial a telephone number, either local (70) or LD (890), will the ARS table still route the call correctly, or when you assign a button to grab next available line, do you...

Thanks ttech. For clarification, my set up is currently as follows: LDT1 (inbound toll free, outbound LD); TRK 801-824; Pool 890 Local; TRK 825,826,827,828,833; Pool 70 Inbound Fax; TRK 829,830,831,831,834; Pool 891 Outbound faxing and outbound calling follow the ARS tables: Toll Free...

Tom, you rock! Thanks for the info. I see your name all over the forums and it is appreciated. I will try it this weekend and let you know how it goes. THanks, Mike

Hello All. There was an older post on this, but I have some new questions that it didnt answer: Currently my fax lines are configured to use the existing pool 70 for outbound calling. We use an access code of 9 for outbound calling so fax numbers come through with 9,,011etc. Sometimes, this...

He he he he...Very True! Thanks again for the help!

Ok, I have to admit I made a mistake. But, I have to admit that all is working now! Thanks to all of your help. I did a print of the extension directory: A 7/15 4170 FAXSVR3 N N N N U 3 N 7/16 4171 FAXSVR4 N N N N U 3 N A 8/ 1 7172 VM1 N N Y N U 0 N 8/ 2 7173...

Merlinman, yes, they are set to unrestricted. Tom, selector code 4 is for direct extension transfer, (i still need to redo my autoattendant to make code 5 a direct extension transfer too), I also use *t to test both ranges. Any 4100-41xx (except the ones that i moved to the node location) ring...

Thanks Tom. I took the VM extensions x7172-x7179 (for my 8 ports)...I made sure that Rotary Enabled was set, that they were unrestricted, TrunktoTrunk is enabled, RCF enabled...but still cannot get to Slave site through the automated attendant...but i can transfer to it fine from any Master...

No, what does rotary enabled do?

when hitting *t, i am prompted for extension, i type in x4132 I hear hold music for a couple of seconds and it rings out to the operator...same thing as when i try extension without hitting *t. Any Idea?

cool, i didnt know that you could do it without the switch numbers...i guess i was taught differently because i had central VM set up. But , in any case, I have the switch numbers on the Point to Point, and it is still failing. I double checked what Tommy mentioned earlier...and I am still...