Recent content by Inuit

any 6 digit goes to the 403 any other goes to the PRI.

That would make outbound calls go the wrong way..

Correct. And yes i know it sounds wierd. Its VoIP calls coming in on the pri(406) going out on the public network via the 403. The huntgroup part i figured out. I made a shortcode and routed the DDI to that. My problem with other part is getting the 403 to dial the number wich was dialed to the...

No idea what traditional networking is. Please explain PRI Qsig. Dunno if this helps but the 406 and 403 is trunked with an IP trunk and PRI30 is an interface to an Asterisk server. What im looking for is how and where i place shortcodes to direct the calls.

2 questions.. If i have a 406 with a pri30 trunked to a 403(bri). Can i direct an incoming call on the 406 to go out on a bri line on the 403? Also can i direct an incoming call from the 406 to a huntgroup on the 403? In both scenarios SCN is not enabled. Any ideas??

Version 2.0(16) you have to be on site or have someone on site doing it for you. I have a lot of sites i cant go to. I usually ship a CD. Have someone installing the the manager and control it remotely. As stevepaz said "play it safe".

Hi all, Heres a funny one. I have a customer using delta server to generate reports in custom made software. At some point calls made out of the country (all starting with 00) shows as VOICEMAIL in smdr_output. Calls inbound shows correct. Anyone have any ideas?? KR Flemming

Hi, Anyone able to give me some basic knowledge on how to connect to the PABC?? I only need to switch an extension from analog to digital and i have never worked with one before. Also what is the default password? Im pretty sure its never been changed. Im guessing i have to use a hyper terminal...

VOiD did you try putting both to 2.1(24)?? /Flemming

I have set up a test and it shows that it was not a software issue. Guess i have to check the config again. Could it be a VPN issue? I have to do more testing. TY for your time. /Flemming

I have 2 sites where one calls on other sites ISDN2 line. However i have a problem with a FAX being routed back to its origin(well thats what i think that happens) because of SCs that route ext calls between offices. The office with the ISDN is running 2.(16) and other office 2.1.(24). Any...

BTW a reboot solwes it.

Anyone seen this? When i make a change and merge instead of reboot(as the manager suggest) then i have a system SC that overrides a restriction SC. System SC is ? . 1 DIAL. And Restriction SC is ? . 0 DIAL The first SC should not be needed but if i deleted it noone can make any calls if i do...

The AT-X command erase the Box and only leave the "loader". You use the loader to upload new software. You cant send a new config after AT-X has been done. What you need to do to repair is this: Connect a PC to the IPO both to the DTE and one of the LAN ports. Get the MAC adress and IP of the...

Bah stupid me didnt read carefully enough. Needed manager on broadcast for it to work. Sorry for taking your time. Flemming (The IPO noob)