Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by igolftoo
-
OSPF Config issues
yeah I'm "trying" to be a CCIE...I plan on taking the lab in October of this year. I was of the opinion from the begining that the practice lab objectives were a bit off but I wasn't sure. After going through cisco documentation and your explaination, I'm convinced that the lab is wrong (I guess... -
OSPF Config issues
lol....I'll ask the IE Lab proctor to contact you if I have the same problem on my real IE Lab...:) Thanks -
OSPF Config issues
Tried that but no luck...I think the lab objectives are messed up. It says that I can't sue the "ip ospf network" command on this perticular router. I'm at a point to where I have left that portion out for now....:) Thanks everyone for all your help. Regards, Malik -
OSPF Config issues
If you look at the config that I have posted, you will notice that I have configured the sub intf's as multipoint int's. My understanding is that frame-relay physical and multipoint intf's default to ospf network type Non_broadcast....is that correct? If that is the case, I should be able to use... -
OSPF Config issues
I just noticed this after I restarted the router for the 50th time...-:) 1 Ethernet/IEEE 802.3 interface(s) 2 Low-speed serial(sync/async) network interface(s) 1 ISDN Basic Rate interface(s) 32K bytes of non-volatile configuration memory. 16384K bytes of processor board System flash... -
OSPF Config issues
Here is the running config from the hub router. Eliot8: yes the neighbor relationships are forming and everything works as it should. The problem only occurs after a reload. The thing that is driving e crazy is the fact thet only the neighor statements are falling off, nothing else. hostname... -
OSPF Config issues
I did check the cisco documentation but it doesn't really talk about "not" using the "ip ospf network" command. I will post the config first thing tomorrow morning. Thanks -
OSPF Config issues
I having a little problem with saving OSPF config. According to the lab objectives, I can't use "Ip ospf network" command. So I went ahead and statically defined OSPF neighbors (using point-to-multipoint sub int). I saved the running config and reloaded the router to make sure that nothing... -
2620 and IGRP
You are right rainman. I did little bit more research and found out that "Beginning with Cisco IOS v.12.3, Interior Gateway Routing Protocol (IGRP) will no longer be supported." One less thing to worry about..[bigsmile] or :-D Thanks for all your help guys.... -
-
2620 and IGRP
Hi guys, I'm studying for my CCNA and have couple of routers to practice on. One of the router is a 2620 and I can't seem to configure IGRP on it. Every time I try the command "router igrp 100" it gives an error message "invalid input detected.....". When I try router ? it shows the following...
