Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ianlawuk

  1. ianlawuk

    Trunk Verification Testing

    Hi I'm aware of the TVA on an anlogue set to do the truck verifications, but i'm being told that this works for DASS but not Euro-ISDN (ISDN30E's) and the only waty to test ISDN30E trunks is to disable the preceeding trunks in the group and then dial out as normal. Is this correct, is there a...
  2. ianlawuk

    Nortel 3902 to Cat 5

    Guys The issue was related to different structure cabling within the building, with different outlets etc having different pin combos. Nightmare. Finally worked out I needed a straight through RJ 11 to RJ45 phone cable, whereas the one I was using for testimng had crossed pairs.
  3. ianlawuk

    Nortel 3902 to Cat 5

    Its definitely a 3902 as we have many of these, its common place in our building, so not an IP phone, and as I say we do have it working in the office. DKF: I have mate, first thing i tried, reversing the wires to the pins. All logic says this should be working, I've been working in this...
  4. ianlawuk

    Nortel 3902 to Cat 5

    Hi Guys I have a working 3902 in an office, connected directly from the back of the phone to the RJ45 socket on the wall. OK no probs! If I take this phone with cable into the comms room where we have the TJF Krone frames, And punch a pair of copper into the TN on the frame and the other end...
  5. ianlawuk

    SCCS5.0 Database Fields Missing

    Uninstall and reload - did not fix problem. We are getting a DMS view of the database rather than an M1
  6. ianlawuk

    Urgent HELP required

    No migration disk... So the whole restore was abit messy. We evntually got it working.
  7. ianlawuk

    SCCS5.0 Database Fields Missing

    What it looks like, is that we have the database views/definition for a DMS and not the M1. Do you think the removal / reinstallation of Sybase and data restore would fix?
  8. ianlawuk

    SCCS5.0 Database Fields Missing

    Hi guys We've recently recoverd froma system failure on SCCS5.0, involving a restore of the database. Runnging the report - Config - Database View Definitions, we seem to have a different set of views than before. Comparing the database to another site (also on v5.0) , it is very apparent...
  9. ianlawuk

    Urgent HELP required

    Thanks for your replies so far. The partition sizes are the sames as before the reload. I think the clean rebuild has created 'default' database sizes within the partitions, so the 24gb won;t fit into the system allocated space. We are now trying a migration style restore which sounds like...
  10. ianlawuk

    Urgent HELP required

    We have just had to rebuild our Symposium 5.0. We have created a 4 partion disk for the database with each partition @ 16gb (total 64gb). When we try to reatore it gives us an error saying the databse requires 24gb. Any ideads why we can;t load the 24gb data into the new build? Thanks
See more

Part and Inventory Search

Back
Top