Recent content by Hpunch

I am installing software that uses the Windows Installer program. I get an error message "Installation Error 1603: General Window's Installer Engine error ... Increase Disk space in setup.ini" I have tried installing on two different NT4 based computers, but I receive the same error...

I have a clone PC, running dual boot into NT4 and Win98. I cannot start the system, no beeps on startup the system will work during the day, but at some point, it will freeze up in NT and chkdsk would occur upon rebooting, a freeze would occur again and therefore would need a cold bootup which...

Thanks for the info everyone<br><br>I tried booting up with a DOS boot disk and I ran scandisk, but scandisk could not read drive c:, but it could read other drives.<br><br>I am able to get into directories on the c: drive using a Dell Diagnostic diskette.&nbsp;&nbsp;Is there anything in Windows...

Thanks for the info kb244.<br><br>I'll try to get more info.&nbsp;&nbsp;Do you think typing in fdisk /mbr would help?<br><br>Thanks

After the detection of floppy a: on bootup, the pc does not bootup further.&nbsp;&nbsp;I do not get a DOS prompt or any errors.&nbsp;&nbsp;I booted up with a boot disk, but when I get into the C: drive and try changing directories, I get an error &quot;file allocation table bad, drive...

I am running Exceed v6.2 through an Aventail VPN using LBXproxy.<br> <br> If I don't have the aventail VPN setup, LBX runs fine.<br> <br> The problem is that when I send a command using LBX to a UNIX machine that is within the VPN, the ipaddress is translated when the command comes back to my...

Can you use the Escape (ESC) key and the Up Arrow key on a standard 101 keyboard to toggle through your previously used commands in a dtterm window. This is similar to DOSKEY in DOS and the history command in vi. <br> <br>