Recent content by hiescham

Hi Siadna ! What type of command lines do you want ? hiescham's Technical Support

Hi there ! As far as I know u can install the Auto. Attendant Machine in MD110 system. It is a out source / out band system to connected with MD110. There are many sorts of module that you can choose. You just needs to programme certain extn. and initiate a new GH (Group Hunting) GHDAP:GRP=A...

Hi there! Here I enclosed you the codes for AC(Account Code) Service codes: Account Code Account code (ACO = 1-15 digits)(EN = External Number) *61*ACO# EN PARK *61*ACO# REFER BACK hiescham's Technical Support

Hi there ! In Q-SIG you can apply the Callback between A-Site to B-Site and you must arranged to numbering plan. Here I enclosed the parameter to initiate Q-SIG. Parameter for Q-sig. ROCAI:ROU=XX,SEL=011000000000,TRM=6,SERV=21100000000,TRAF=03151515,SIG=51111 0100031,BCAP=111111...

Hi there..! Please e-mail me personally at hiescham@celcom.net.my I will send a documentation that describe an AXE OG11 & OG21. hiescham's Tech. Support

Hi there ! Try to remove the IPU card from it's position and wait for 2-3 minutes and slot in back. After that try logon again, or you can try to change the Quater Plug Position. If it's fail try to change the IPU card with new one.

Hi there ! I would try to help you dealing with the MD110...but can you please tell me weather you using DNA or the ordinary FIOL or WinFiol version... and what software you are using?

Hi Gred .., I'm not sure about the case that you been through. But can you please check back the syntax in ROCAP, OPTCP and the extension SERV.