Recent content by hawkflorida

Thanks,

A customer would like to have this ability. Is there a way of showing the DGH "port" status of a digital phone port on the DGH GW other than active sets that are shown in the operator panel? Though the OP doesn't actually show the ports.

Thanks ucxguy

The system is a UCX50e (sw 4.5). Can you have paging groups where the group members are Polycom VVX telephones?

I'm looking forward to hearing more concerning eMetrotel. :)

Thanks TomMills, for your being of help .....

When I set up a phone to Call Forward Externally from the unit it works perfectly unless you dial that extension from the Auto Attendant. I can call the DID of the phone or have someone else answer and Transfer me to the phone and it will forward with no issues. I can set up a CCR Tree in the...

What is the PC IP address & subnet mask? Can you connect using Internet Explorer? If you can try downloading EM from this unit. Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.

If you reboot the BCM50 does the problem go away? If so it is likely a patch issue. Though this would be an older sw rel of BCM50. Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.

Have you looked into a possible line supervision issue? Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.

Reporting issue also seen on BCM, see thread 1361-1522101. Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.

Try downloading and installing Element Manager directly from this BCM. I've seen this work. Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.

On one system in this set up that I am using is an upgraded BCM50 Rls1 to Rls2 and so I don't think it's the issue. Heck, I've been wrong before so I'll look into that angle. I'm beginning to think my quote is coming into play here.... I regret that I am not helping you quickly enough. In...

The trunks on the far end(MICS and CICS) have Answer Mode set for Auto and DISA is turned off right? I know you said they work dialing back and forth to one another but I was just wondering. Can you make a desti code of 3 with an absorb of none on the BCM50 routing and 3 on the IP trunk digits...

What are your settings in the BCM's Remote Gateway tab under Telephony Resources? Consulting - If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem.