Recent content by haasd0g

Bump

thread799-1773014 Did this get resolved? I'm having the same issue and swca is not helping. Once a call is accepted on a set, no more calls will ring in at that extension. I have 3 intercom keys. Any guidance would be appreciated

Curly, youre making me question all that I thought was right and good... I put the phones in a pickup group and gave them all a f75 key, which is not the worst fix for this small office. Tomorrow morning I will be heading over to the mothership to see if I am crazy thinking my original system works.

Literally, $75 for the solution Please, someone set me straight before I blow my head off... - BCM400 - Remote site on MPLS Network - 6 2004 IP sets w/3 intercom keys The following is an example, but condition exists on all phones: Calls are transferred to HG via AA and broadcast to said 6...

I just put a Soundstation2W in for one of my customers. It works like a champ- great range and clarity with no extra mics. Just hook up an ATA and youre good to go.

I have trisys at 4 customer sites. Works very well.

Systems are on a private network with T1 at all locations. dtc- Im a VOIP n00b. Where do I verify my payload size? I couldnt find it in BEM.

Greetings, I have 4 sites; (1)BCM400 and (3)BCM50. All have PRI and VOIP trunks. When dialing between locations, the person receiving the call can hear the caller. But the dialing party cannot hear the destination. This will happen anywhere from 2-7 or 8 times, then go through, crystal clear...

I will be following this thread. Same problem - 4 sites; (3)BCM50, (1) BCM400. Echo on PRI- sometimes. One way transmission 2 out of 3 calls on VOIP-thats for another thread though.

Worked like a charm. Thanks so much. You the man Tommy!

Hey guys, Though relatively proficient with Nortel, Im unschooled in Merlin. I added a couple new extensions for a customer and they asked me to set up VM as well. I got them built no problem, recorded names, changed pw, and chose 'yes' for having a phone associated with it. My problem is that I...

anyone still listening?... the mobo was indeed fried. i purchased a ASUS p4s800d x thinking my problems were solved... i can get into the RAID utility, but it appears as though i will lose all my data by creating the RAID. Any suggestions on how to not lose everything? (no wisecracks about...

cd-r cost around 25 cents apiece- or less. my advice; forget about rewriting. cdrw have been a headache every time ive tried using them.

Assuming this was working fine and now it isnt... could be the drive died- that happens every now and then depending on usage. I get a new one every 18 months or less. If its a newer drive or you are new to the cd writing software you may want to try Nero burning rom. Trialware is available on...

i attached another power supply - did NOT power drives, but got the same result with no display. Im not sure how to reset CMOS... So I find myself back at the mobo and plea to anyone with connections for old hardware to tell me what i can replace this board with and from where. I need: 1) Socket...