Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by h5n1

  1. h5n1

    CM 3.1 SHELL problem

    Hi Steve, I've issued your command dadmin@S8720A> stty echo dadmin@S8720A> however, still not able to echo what was typed. I've read thru the MAN page for stty but doesn't seems to have anything else relevant.
  2. h5n1

    CM 3.1 SHELL problem

    Dear all, I was not able to echo what was type within the shell, is this something that can be fixed ?
  3. h5n1

    Playback is blank after sucessfully recorded announcement

    Dear all, The switch and VAL board allows successful recording, but it will playback nothing. Seconds shows correctly in "list integrated xxxx". Existing announcements plays fine. -------------------------------------------------------- VAL-ANNOUNCEMENT TN2501AP HW13 FW016 Time...
  4. h5n1

    AUXOUT time

    Dear all, Agents will be AUXOUT after 3 rings if they don't answer an ACD call...where do i change this time or number of rings? Thank you very much
  5. h5n1

    IPSI and S8720

    have you define your node-names?
  6. h5n1

    Inbound ANI show on LCD instead of VDN name?

    if you do a list trace on the trunk and in there it shows no name that means your carrier isn't sending you any ANI or the caller is calling from a number which doesn't have outbound caller id which is also programmed at the telco's end....usually if there's ANI info it will pass thru your VDN...
  7. h5n1

    MM711AP

    could be a firmware issue on either the MM711 module or the S8300....i would submit a ticket to your BP or avaya to have a look at it
  8. h5n1

    Transfer Ring Time Out

    create another coverage path using 'add coverage n' should be your next one....ie 107, program it just like coverage path 106 and see if 107 works after 6 rings....if it does do a remove coverage 106 and just use 107. could be a corrupted entry in the coverage table i had that once....
  9. h5n1

    IPSI and S8720

    did you create an ip-service and bind SAT on one of the CLAN's?
  10. h5n1

    Avaya Integrated Management for Windows Vista

    Dear all, What is the current status for Integrated Management on Windows Vista? Does it work on Vista with the current Integrated Management 4? thanks
  11. h5n1

    ARS digit conversion

    on the trunk form i think either page 2 or 3, try putting a 'n' to suppressing # and monitor it for a while....
  12. h5n1

    Integrated Management Tool - Voice Announcement Manager

    excellent CBB...i will give that a try....
  13. h5n1

    Integrated Management Tool - Voice Announcement Manager

    Dear all, I'm trying to install the VAL management tool (3.0.16) but it will not begin the installation with this error message: "An unsupported version is detected, please install this current version or upgrade the current version" and exit the installer. I have ASA installed on my notebook...
  14. h5n1

    Main Server and LSP restart intermittently

    bidon123 main and lsp restarts? or main restart for no reason causing lsp to restart? what CM version on both? run 'disp init' do you see the restart cause? any alarm or error?
  15. h5n1

    RE: going for the 4th time - ENDING

    Dear all, recall my last post on going for the 4th time: 1st attempt: 821 / 849 2nd attempt: 770 / 849 3rd attempt: 834 / 849 4th attempt (today): 910 / 849 I FEEL GOOD.....DA DA DA DA DUM..... =)

Part and Inventory Search

Back
Top