Recent content by gymnast

hi aixqueen, i tried this one but maybe i need to start from scratch as i cannot fully setup email. what i want is that i should be able to send and receive emails from/to another network. we do have DNS server and my machine was already configured on that server. is there anything i missed...

bill, it's working, yes! but i didn't confirm if the sysadmin did something to make it work. i just want clarification. do i have to define my e-mail server in DNS server? 'just got confused.

marc, have you tried umounting FS first?

tamuzi, thanks a lot! works perfect!

thank you bill...it works...

nick, try to check printer setting using smit, it'll tell you and show you some default config that you may want to change. btw, is it a network printer?

try this: 1. check if the two machines (AIX/Solaris)are on the same network, say - the default gateway. 2. check/try to use "ping" command (e.g.,ping{ip address}) 3. check your /etc/hosts table - define each server in each hosts file

thanks bill, works fine now except that i'm not quite sure if i have to define all the local users (ID) in the /etc/aliases file. sorry, i got the materials from IBM (attached below) site but not descriptive enough to apply in my system...

any suggestions here? takers? i tried setting up and configuring sendmail.cf file, specially the Cw, DM part... i was able to send and receive, but receiving is just a matter of clicking the reply button. i'm trying to find out what's the meaning of the following stanzas inside the file: #Cw...

1212205, 'know what? i think the machine that you have now is most likely nice to play with specially with AIX 4.3. but replacing it with linux or other OS, i never had experience and heard off... you can still sell it for $2,000 - 2,500, considering that the future owner has no warranty at...

hi everybody! my situation: i want to setup/configure my rs6000 (AIX) box to send and receive e-mails from a dns server. it's like, i should be able to send and receive e-mails through an NT box. the reason for this - is that i got #s of dumb terminals and these terminals are being use to...

thanks call, but i don't want to create a new VG. all i want to do to give room for growing DBase is to copy the entire hdisk1, which is datavg to a new HD with 9.1GB and remove the original HD for datavg, leaving the new 9.1GB HD (as the new datavg). i think, critos' is right except that...

hi christos, thanks for the tip, but: initially the system recognizes the hdisk which is hdisk2, but when i'm about to add it to datavg, i encountered a problem: PP size of 4 requires the creation of 2169 partition for hdisk2. limitation is 1016 PP/disk. specify a longer PP size in order to...

thanks aixqueen.... i got the solution, here's how: 1. downloaded the right network driver for the said printer. * on lexmark CDROM, go to drivers, then aix directory - get file named LXMARK4X.TAR * untar the file, then run the install_pkg program under that directory, then select appropriate...

hi everyone! i got this problem: i'm using aix 4.1 and i successfully connected lexmark network printer.... the thing is i got this garbage from the top of every page every time i'm printing...usually i used the default parameters of each printer and its drivers, as well as aix default...