Recent content by GuauGuau

Hi! Patcher, I'm thinking about if it's possible with LSCOE. Do you think it's a good way?

Have tou checked NUTRP; settings? If B-number conversion isn't correct, calls could be rerouted to operator console. You should check traffic matrix (TCMAP:CON=T;) too. Good look!

NUTRI CNVTYP can be: 0 Received B-Number 1 Sent A-Number and sent connected number 2 received A-Number and received connected number 3 Bearer capability/high level compatibility substitution

ROCAC doesn't admite CAT. EXCAC or KSCAC yes, ROCAC admite ROU SEL SIG TRAF TRM SERV DIST DISL NODG and BCAP.

I told you ROCAC, it was a mistake. Changing ADC: RODDP:DEST=0; (View configuration) RODDE:DEST=0; RODDI:DEST=0,rou=81,SRT=2,ADC=0030000000000250000; (Change) NUMTYP: 0 Unknown public 1 International 2 National 3 Network Specific 4 Local Public 5 Unknown Private 6 Local Private 7 Level...

well, we will go slowly. You need try several configurations. I think you have configured the route as public becose a license. I have done that one time and it works fine, it shouldn't be a problem. ADC of the route that you has sent have 18 digits, check it. I think number five was in fourth...

I'm sorry!!! Yesterday I was really wrong with NUMTYP at NUTRI. Probably MDMAN was in the correct way. Your route is defined as Public in RODAI. (D4 VARO=1 public, =0 private). But is defined as Tie Line at ROCAI (D3 SERV=0 Trunk Line, =1 Tie Line). NUMTYP in RONDI is Network specific (3), but...

I’m not sure if the route is private. MDMAN surely will tell you if the route is private or public analizing route parameters. MDMAN told you a very good information with NUTRY, but I think that you need traslate the whole number, like that...

Hi! As i told i can remember well this command. But if Route 81 is private, you need use EXNOPR parameter instead EXNOPU. If number isn't well composed, you can't traslate it well with NUTRI. A-number is composed with EXNOPR (private route), or EXNOPU (public route) and extension number. in your...

Hi! I haven't got any documentation here, but maybe can be a problem with RONDI configuration? Probably not, but it is another command to compose A-sent numbers. You can print it with RONDP:ROU=X. Good Look!

The PBX is a MD110 BC9 Packet B. Thanks a lot.

Hi! I need to connect an 30B+D ISDN interface of a CISCO router to public ISDN Network. I'm thinking about connecting it to a TLU76, and do transit through MD110 to public ISDN network. I don't know if TLU76 can do that. Can TLU76 emulate public ISDN? Could anybody help me? Thanks a lot. Sorry...

Hi! I don't know what's your problem with callback. But it's typical that it doesn't work if you don't active "closed numbering plan" with ROCAC command. I don't remember exactly the parameter, and I haven't got any documentation here. Maybe in SERV inside ROCAC. By!

Hi! I don't know what is ALEX-libery. Is a documentation like Dinatext? Thanks a lot!

Hi! Sorry my bad english! Check if you are chaining divertions. MD110 manage External Follow-me like a divertion (not like follow-me). If the incoming call, has been rerouted to an diverted extension, the call will not be diverted (rerouting is managed like a divertion too). Divertions can't be...