Recent content by grimland

Should there be any problem with NFS mounts going thru the firewall? I have one rule in stating allow all for all services, shouldn't NFS mounts be able to go thru? Thanks

Should there be any problem with NFS mounts going thru the firewall? I have one rule in stating allow all for all services, shouldn't NFS mounts be able to go thru?

I'm having difficulties setting up my firewall. I have 2 interfaces on the same subnet (10.9.8.x). I have 1 interface going to the router and 1 going to a switch. (routergoes to the internet and switch goes to my LAN). With the 1 going to the router I can ping the router but not the switch...

I could use the instruction as well. Thanks in advance. Joe (joegrimland@hotmail.com)

I have a test network and have a UNIX machine representing www. I have it hooke dup to a hub and I have a NT machine hooked up to the same hub but neither machine can ping the other. On the UNIX box, I went into the /etc/hosts and put the correct information in there, but someone told me I had...

Thanks for the reply. I figured it out yesterday after some more trial and error. This is a test network I am running. I am making the NT workstation a router essentially. Configuring three NICs is new to me. I made on for the intranet, 1 for the internet and one for the DMZ. I am trying to...

Hey how did you get the NIC cards to be recognized and running (inside and outside) on one machine. I can't figure it out. Thanks buddy.

I have a NT Workstation with two NICs. I have Raptor on this workstation as well. I need to configure the NICs for internal and external so the traffic goes through the firewall, right? How do I do this? Your help would be appreciated. Thanks. Joe

I have a class b network. How do I make sure the 2 IP addresses are on different subnets? Right click on Network Neighborhood > Properties > Protocols > TCP/IP Protocols > Properties and then IP Address tab...(done that). I am confused though, I just see one IP, how do I see the other one...

I am trying to configure a workstation (that has 2 NICs) to have one NIC with an address of (let's say) 150.150.150.1 and another to have an address of (let's say) 150.150.149.1. The reason I'm doing this is because I am building a test bed and will be putting a firewall on this workstation. I...