Recent content by goddy1

I have a CICS /not sure about software version/It is 1998 or so vintage. What cards and what level of software would be required to bring it up to 8 lines/24 stations? Can it be done?It has a 1 port Flashtalk mail system.

going to power down and move both a block away/Is there any preferred power down/power up sequence so as not to lose any programming? ie sytem then mail or visa versa

can't remember for the life of me/the 50 pin connectors male or female/can't find in manual

no video card, monitor right into connection on mother board

have an AMD 1.53 MZ/// Sytem Properties show 192 mb ram, but I have a 256 mb memory board plugged in.Is something installed wrong? Should it not show 256 mb in System Prperties?

thks linney/stop WIA/instant speed/not sure what the tip was all about/not a real good explanation/but it worked

son's comp got so full of virus and spyware items it wouldn't run/had to reformat drive and reload the operating sytem. everthing seems fine internet acess really good,anything from the quick launch is quick, but any applications from the desk top or trying to open a directory from windows...

What would be considered as the standard in terms of inside wiring from the Telco demarc to the adsl modem. I have a problem with the network connection going up and down. The existing wire is 400 ft of non twisted. It would probably be good place to start by replacing this cabling. Your...

does anyone know if there are optimax 2 field connectors for singlemode, if so can you use the optimax2 installation kit for them

WHAT,S THE MAX DISTANCE FOR A OP STN USING AN ATA

looks like am trying to make a cadillac out of a volkswagon. So with my simple sytem ccr will transfer the call to the recording, a digit will be dialed and it will present itself at the line key of the one and only dn in the group( each group has one dn) as a transferred call(with the shorter...

I'm installing(some experience), but rather new. Customer purchased a refurb and it turned out it had a bad software card to start with. I installed the ccr per the documentation and help from tek-tips.After I installed it and ccr was working if someone calls in,gets the recording and dials...

If lines ring only, then they can,t callout,or can they by dialng 9 for a line pool?

ccr answers call, goes to greetings(open for Business),you dial 1 for lets say 22. The line button rings at that dn22. Is there any way you can have the intercom of that dn ring instead of the line? have a dn on an ATA. programed into a grp 4 under sys programming. admin program I put dial 4 as...

thanks for all your info, it backed up the programming I had done and made it a lot easier to convince the supplier that there was a problem with the software card. they sent me anew one and presto, it works. I haven't done one for awhile so I had to make sure I was doing it write THANKS AGAIN...