Recent content by gfielding

I have re-answered question 2 in a little more specific fashion. 2. If remote is ok, can it be connected via fiber optic (number of strands and type MM or SM)? An SI EPN can ONLY be connected via fiber as follows: R9 and down: 9823A Transceiver - Multi Mode Fiber - 62.5 micron - 1 Mile...

1. Can the EPN be remotely located from the G3SI or does it have to be in the same room? Remotely located is just fine. 2. If remote is ok, can it be connected via fiber optic (number of strands and type MM or SM)? An SI EPN can ONLY be connected via fiber as follows: 9823A...

Hi all, I have an S8300 configured as an LSP off of an S8700. It all appears to be working fine except the S8300 keeps getting a Watch Dog error every minue and a half or so (weather I am connected to the S8300 or the S8700). The error is as follows: Source: WD Event ID: 18 Application...

Hi All, I have an S8700 with an S8300 configured as an LSP. It seems to be OK until the link goes down and the LSP does NOT come on line. I have also noticed that when the link is up the S8300 seems to have no translations on it (when being accessed through the services port). Does anyone have...

Hi all, Has anyone else out there ever deployed IP Hard Phones using UNIX servers for DHCP and TFTP? If so are there any pitfalls that I should watch out for? Thanks, G

Do you have line of sight between building one and building two (same question for building one to building three)? If so, you could do a point-to-point, point-to-multipoint, point-to-point solution. It would look something like this: _ Bldg 2...