Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by GDLNORTEL

  1. GDLNORTEL

    Sip Line Gateway Elan Down

    Hi guys, I have a SLG in SS CPPM but the problem is the ELAN link is down, how enable the elan? I try whit enl elan command but not works, the point is I have a cs1000e whit 2 nodes boot SIPGw, I want establish VTKRs with SIPLineGw a other PBX MITEL over SIP trunks. Node ip 180.9.1.100 Ip...
  2. GDLNORTEL

    PROBLEMS WITH PRI SLIP ERRORS

    in the slot 6 is a DTI2, E1 to PSTN
  3. GDLNORTEL

    PROBLEMS WITH PRI SLIP ERRORS

    the law is A in the trunks
  4. GDLNORTEL

    PROBLEMS WITH PRI SLIP ERRORS

    It is connected to E1 signal, that it provides celular calls, with the characteristic PRI ISDN (EURO ISDN) for ITU-T REC. Q921, Q931 but with Euro Signal don´t works. The connection in the pbx is coaxial and the other side is RJ45.
  5. GDLNORTEL

    PROBLEMS WITH PRI SLIP ERRORS

    sorry guys this is the status of the clock .SSCK 0 ENBL CLOCK ACTIVE SYSTEM CLOCK - LOCKED TO SLOT 6 NO IS LOCKED TO SLOT 4....
  6. GDLNORTEL

    PROBLEMS WITH PRI SLIP ERRORS

    HI GUY´S I Have a problem with E1 PRI, many SLIP present in the counters and this originate a blocked channels. The card is a number part NTBK50 in OPC11c Release 25.30. What suggest??? This is the configuration: ADAN DCH 4 CARD 04 PORT 1 DES...
  7. GDLNORTEL

    BCM Vs AVAYA

    I connect a system PBX avaya with bcm 400 like gateway, where avaya is the PBX, and bcm connects with a DTM to a T1 the users take line with the 7 access code,but when the marking of fast way or or they use redial, i.e. from canada dial 7 more extension 1234 of the mexico, then the BCM does not...
  8. GDLNORTEL

    DTM is flashing

    Thanks acewarlock the problem already this solved, i understand the resources the DTM it already was in put the Bus 7. Only change the module of the slot and Disable/Enable this ready one.
  9. GDLNORTEL

    DTM is flashing

    Hi, i new boy in this forum, i installed the bcm 400 with DTM Module for T1 in Canada, in this moment dont connect T1 in the Module but all leds are flashing, as I can solve it? thanks
See more

Part and Inventory Search

Back
Top