Recent content by GANDERUK

Hi DEP lists are installed. I found the problem. The DASS Routes had LID set to 0 ie not sending CLID. Changed LID to 1 so now i/c calls on the DASS routes now pass the CLID over onto the Q931 Circuits. As part of the upgrade the NTAK35 DASS/DDSL cards had to be changed for NT6D11 DCHI cards...

Here you go John Cheers Dave ld 21 PT1000 REQ: prt TYPE: rdb CUST 0 ROUT 5 TYPE RDB CUST 00 ROUT 5 DES TKTP TIE NPID_TBL_NUM 0 ESN NO RPA NO CNVT NO SAT NO IDEF NET RCLS INT VTRK NO NODE DTRK YES BRIP NO DGTP PRI2 ISDN YES MODE PRA IFC SL1 PNI 00701 NCNA YES NCRD...

Hi Guys Recently upgraded option 61c from 25.15 to 4.5. All is fine apart from an issue with CLID, A call is made into the switchboard on the upgraded 61c the clid (ie my mobile no. is shown on the console display, if the call is then transfered over a Q931 circuit to another option 61c all...

It depends on how far away the consoles are from the Option 11 . If in excess of 50 metres you will probably need the power TNs . If less than 50m you should be ok without them and therefore you could use the TNs for digital sets

Hi All the polycoms Ive Configured have been done as analogue sets in LD 10 I have never come across a digital polycom Cheers Dave

Hi Octel is a stand alone voice mail system normally works to a Meridian using 2616 handsets configured with mik/mak keys