Recent content by foned00d

Having a problem with our conference server. CM 4.0 We have some A/V equipment that dials out via an analog line off the PBX. Whenever that equipment is used to call into our conference bridge the caller is significantly lower volume than everyone else. I did notice hte ip-codec was set to use...

Looks perfect, Thanks for the info. I tried looking on the support site but it can be so frustrating to search on that site.

Our IT security dept is requiring we change how Avaya connects to our systems for support. They want all the modems out of the environment if at all possible. So here's the question, does anyone know if Avaya can support a B2B VPN connection to provide support services?

The problem seems to be the server is trying to send packets destined for the local subnet to the subnet’s gateway. The gateway will drop those, we should never send traffic local to the subnet to the gateway on the subnet. But I can't figure why the server is doing this..

we have 2 interfaces, .17 is the gateway for .25 (eri0) and .1 is the gateway for the .13 (ce0)

Not sure, All I did was replace the existing IP entries with the new ones... here is the netstat, as far as I know I shoul dbe talking out ce0 to the .11 address # netstat -rn Routing Table: IPv4 Destination Gateway Flags Ref Use Interface --------------------...

We change the IP address of our Solaris 9 box and now we can't get connected to one endpoint. here is the error while tracerouting to xxx.xxx.222.11, traceroute: Warning: Multiple interfaces found; using xxx.xxx.222.13 @ ce0 traceroute to xxx.xxx.222.11 (xxx.xxx.222.11), 30 hops max, 40 byte...

I guess I do not have appropriate permissions to do this as "craft2" is not an option presented to me after "enable

I am trying to add a secondary Dadmin type login. When I get to the prompt to enter a new pin it tells me incorrect pin after I enter it a second time. I've tried multiple times and am sure I am not typoing the password on the second try. any suggestions? CM4.0

Staylor2: Do you have any links with information on this "known problem" I'd like to review and see if it's causing some of the fax/modem issues we are seeing.

I pretty much understand what this means, but how can I tell which PN's are having the issue? Event Event Event Event First Last Evnt Type Description Data 1 Data 2 Occur Occur Cnt 2331 No VOIP channel, PN <-->...

While trying to add a login I consistently get: Error modifying user parameters, system call failed. Password: Your account is locked. Maximum amount of failed attempts was reached. Error modifying password aging parameters. Yet I can login to both the web interface and via ASA with no issue...

We are having an intermittent issue where agents are hearing a DTMF tone while on a call with customers. the only isolation we've been able to do so far is that this happens on calls routed between sites via IP tie trunks. It would seem if it was a misconfiguration of those trunks this would...

The list integ command will only show announcements actually administered on the board. While the LS command via FT will show you all the files on the board. To remove the Files that show up on the list but not on the "list integrated" command sinply delete them via FTP the same as you would any...

Any updates on this one? We are scheduled to upgrade to S8720/ CM4.0 in about 3 weeks. Feeling a little uneasy at this point.