We had the same issue. This is nothing that can be modified through the OB Campaign Manager interface. Avaya can modify the algorhythm to increase the number of contacts per agent and I believe that there is also a patch available for this on 6.1 SP3.
I am also running CS1K 5.5, CCMS, CCMA, CCT & CCMM 5 with SUS07 lineup.
We do run into occasional issues with services synchronization, although it has become more stable over time.
The biggest issues currently is the CCAD clients are disconnecting and reconnecting to the CCMM server...
Where did you check the priorities for the email -- did you check them on the CCMM or in the scripting?
Do you know if these were the requeued emails that were being presented to the agents?
Can you post a copy of your MM call routing script that is queueing these email contacts?
Did you run...
Is there a way to manage the DNC list in the OB Campaign manager in Release 6 of CCM? We have had some agents incorrectly disposition calls as "Do Not Call" and want to be able to remove those phone numbers for CCM's Do Not Call database.
You must route the options to a CDN that is acquired by CCM and is pointed to an application in CCMS. Reporting is only generated on applications (which are primary scripts). Reporting does not peg for secondary applications.
We have 2 CCMS (6.0) sites with CCMA. We are in the process of turning on multicast across our network and both CCMS have the same RSM IP address (the default that Nortel loads). The send IP address in the RTR data send IP addresses are different. Is there any issues with having the same RSM...
We are utilizing soft phones for some of our call center agents. We are wondering if the following is possible and how to implement:
Can the headset button remain active between calls -- we are call forcing calls to agents and the headset appears not to be "on call" between calls
In the scripting guide, under the PLAY PROMPT section, it states the maximum length of a voice segment is 120 seconds. In Meridian Mail, you can record a segment more than 120 seconds, however, we have had experience where when it plays, the voice port that is playing the announcement becomes...
Thanks everyone for your replies...Yes, I do mean the calls getting through to an agent...
The dchannel messaging sounds intriguing, but a little too time consuming and it doesn't give you the historical ability -- such as can you see if Agent A disconnected the call at 4:18 pm yesterday...
Good Afternoon,
In the Call by call data, is there a way to tell whether the agent or caller initiated the disconnect? What does the data look like for each scenario?
Thanks
Fonchick
I am trying to figure out a way in Symposium to report off outbound calls with categories. With Activity codes, I can't enter in an activity code on an outbound call without having the agent go into Not ready before making the outbound call. This pegs as a not ready reason code and due to...
QUOTE: "give the bad pos id to your vendor, they can clear it, if not you may need a new vendor."
I am having the same issue. John, I am assuming that the solution for clearing it does NOT mean reloading the switch and rebooting Symposium...That is the solution my vendor has proposed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.