Recent content by farslayer9

Ok, i've enabled debugging, but I have no idea how to actually display the results. Sorry i'm such a noob at Cisco.

Here is the most recent configuration and the results of a show int (the changes above didn't work). Any help is greatly appreciated!! Current configuration: ! version 12.1 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption ! hostname...

Ok, here's my new config, which I've not yet tried (I'll try it in a second and post the results of a show int if it fails). I was unable to set the NTP server (unrecognized command) and adjust-mss on the Dialer1 interface was also not an option under ip tcp or anywhere else, so I just set the...

Never mind, we found the solution. For anyone interested, the link is here: http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp161272

We have an 1130AG wireless AP that is in lightweight mode and we need to convert it back to autonomous mode. Anyone have a clue as to how to do this? The TFTP commands to load the older IOS image are not available in the current command set.

Hi, I'm a moron, I meant to say that the modem is going to be chucked, I want the 827 to serve as the modem AND the router. Sorry about the confusion.

I've been fairly unsuccessful getting my 827 router connected to Verizon DSL. Here is my configuration (this forum had a few configs that seemed to be working), and any help is greatly appreciated. My DSL modem is a Westel and it is set to bridge, so my 827 must utilize NAT. I have confirmed...

Here's my problem. I need to be able to print both text and barcodes to this printer using VB6. I've looked at another example that sent the ZPL to a text file, then copied the text file to the LPT1 port in order to send to the printer. My problem is that this printer is actually connected...